Asus PRIME H610M-F D4 R2.0 PRIME H610M-F D4 R20 Users Manual English - Page 14
Power Button/Soft-off Button header PWR_BTN, Storage Device Activity LED header +HDD_LED
View all Asus PRIME H610M-F D4 R2.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
10. Clear CMOS header The Clear CMOS header allows you to clear the Real Time Clock (RTC) RAM in the CMOS, which contains the date, time, system passwords, and system setup parameters. CLRTC PIN 1 To erase the RTC RAM: 1. Turn OFF the computer and unplug the power cord. 2. Short-circuit pin 1-2 with a metal object or jumper cap for about 5-10 seconds. 3. Plug the power cord and turn ON the computer. 4. Hold down the key during the boot process and enter BIOS setup to reenter data. DO NOT short-circuit the pins except when clearing the RTC RAM. Short-circuiting or placing a jumper cap will cause system boot failure! If the steps above do not help, remove the onboard button cell battery and short the two pins again to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the button cell battery. 11. Front panel audio header The Front panel audio header is for a chassis-mounted front panel audio I/O module that supports HD Audio. Connect one end of the front panel audio I/O module cable to this header. F_AUDIO 12. Speaker header The 4-pin header allows you to connect the chassis-mounted system warning speaker. The speaker allows you to hear system beeps and warnings. SPEAKER PIN 1 +5V GND GND Speaker Out 13. System panel header The System panel header supports several chassis-mounted functions. • System power LED header (+PWR_LED-) The 2-pin header allows you to connect the System power LED. The System power LED lights up when the system is connected to a power source, or when you turn on the system power, and blinks when the system is in sleep mode. PWR_LED+ PWR_LEDPWR GND F_PANEL +PWR_LED- PWR_BTN PIN 1 HDD_LED+ HDD_LED- Ground HWRST# (NC) • Storage Device Activity LED header (+HDD_LED-) The 2-pin header allows you to connect the Storage Device Activity +HDD_LED- RESET LED. The Storage Device Activity LED lights up or blinks when data is read from or written to the storage device or storage device add-on card. • Power Button/Soft-off Button header (PWR_BTN) The 3-1 pin header allows you to connect the system power button. Press the power button to power up the system, or put the system into sleep or soft-off mode (depending on the operating system settings). 1-4 Chapter 1: Product Introduction