Asus RS160-E2 RS160-E2 - Page 54
Serial ATA hard disk drive connection
View all Asus RS160-E2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
3. Serial ATA connectors (7-pin SATA1, SATA2) These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives. If you installed Serial ATA hard disk drives, you can create a RAID 0 or RAID 1 configuration with the Adaptec® HostRAID™ technology supported by the Intel® 6300ESB South bridge chip. These connectors are set to S t a n d a r d I D E mode by default. In S t a n d a r d I D E mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the C o n f i g u r e S- A T A a s R A I D item in the BIOS to [Yes]. See page 5-17 for details. ® NCL-DSR1 GND RSATA_RXP2 RSATA_RXN2 GND RSATA_TXN2 RSATA_TXP2 GND GND RSATA_RXP1 RSATA_RXN1 GND RSATA_TXN1 RSATA_TXP1 GND SATA2 SATA1 NCL-DSR1 SATA connectors Important notes on Serial ATA • You must install Windows® 2000 Service Pack 4 or the Windows® XP Service Pack 1 before using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0/RAID 1) is available only if you are using Windows® 2000/XP. • Use only two Serial ATA RAID connectors for each RAID 0 or RAID 1 set. • When using the connectors in St a n d a r d I D E mode, connect the primary (boot) hard disk drive to the SATA1 or SATA2 connector. Refer to the table below for the recommended SATA hard disk drive connections. Serial ATA hard disk drive connection Connector SATA1 SATA2 Setting Master Slave Use Boot disk Data disk 4-10 Chapter 4: Motherboard information