Asus SL6000 SL6000/SL6300 user's manual - Page 29

Chapter 3 Chapter 3 4. Default Gateway: Select this channel as default gateway of the Broadband Gateway 5. RIP Tx/Rx: Select send/accept routing updates on the channel via RIPv1 or RIPv2, this setting will only be effective if RIP is enabled in Global Setting page 6. QoS: These settings are used to specify the service category and traffic parameters that are to be applied for traffic over the specified ATM interface. Choose one of the following options depending on your traffic requirements. • None: The traffic carried over this interface will be on a best effort basis without any guarantee of quality-of-service • CBR: The quality-of-service applied to traffic over this interface is that applied to Constant-Bit-Rate (CBR) traffic. • VBR-rt: The quality-of-service applied to traffic over this interface is that applied to Real-Time-Variable-Bit-Rate (VBR-rt) traffic. • VBR-nrt: The quality-of-service applied to traffic over this interface is that applied to Non-Real-Time-Variable-Bit-Rate (VBR-nrt) traffic. • UBR: The quality-of-service applied to traffic over this interface is that applied to Unspecified-Bit-Rate (UBR) traffic ATM Service Configuration Parameters a) MPoA Bridged and PPPoE Relay: * No further configuration parameters need to be specified for MpoA Bridged and PPPoE Relay services. b) MPoA Routed: * DHCP IPAddress Assignment: Select this option if the MPoA Routed Service interface is to obtain its IP address from your ISP via DHCP. * Static IPAddress Assignment: Select this option if the MPoA Routed Service interface is to have its IP address configured statically. * IP Address: Enter the MPoA Routed service interface's IP Address. Contact your ISP for details * Subnet Mask: Enter the MPoA Routed service interface's Subnet Mask. Contact your ISP for details c) IPoA Routed 28 ASUS VPN ADSL Router