Asus VP249H VP249 Series User Guide - Page 16

Detaching the base for VESA wall mount

Get Asus VP249H PDF manuals and user guides View all Asus VP249H manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

2.1 Detaching the base (for VESA wall mount) To detach the base, perform the following: 1. Disconnect power and signal cables. Carefully put the front of the monitor face down on a clean table. 2. Turn the screw counter-clockwise to loosen the screw located at the bottom of the base. 3. Remove the base from the stand. 4. Remove the stand cover. Then remove the 4 rubber tabs from the wall mount screw holes. 5. Align and install the wall mount bracket on the rear of the monitor. Screw holes for VESA wall mount (100 x 100 mm) • We recommend that you cover the table surface with soft cloth to prevent damage to the monitor. • Hold the base while removing the screw. • The VESA wall mount kit (100 x 100 mm) is purchased separately. • Use only the UL Listed Wall Mount Bracket with minimum weight/load 22.7kg (Screw size: M4 x 10 mm). 2-1 Chapter 2: Setup

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
2-1
Chapter 2: Setup
2.1 Detaching the base (for VESA wall mount)
To detach the base, perform the following:
1.
Disconnect power and signal cables. Carefully put the front of the
monitor face down on a clean table.
2.
Turn the screw counter-clockwise to loosen the screw located at the
bottom of the base.
3.
Remove the base from the stand.
4.
Remove the stand cover. Then remove the 4 rubber tabs from the
wall mount screw holes.
5.
Align and install the wall mount bracket on the rear of the monitor.
Screw holes for VESA wall mount
(100 x 100 mm)
•
We recommend that you cover the table surface with soft cloth to prevent
damage to the monitor.
•
Hold the base while removing the screw.
•
The VESA wall mount kit (100 x 100 mm) is purchased separately.
•
Use only the UL Listed Wall Mount Bracket with minimum weight/load
22.7kg (Screw size: M4 x 10 mm).