Asus X900-PI P3C-E User Manual - Page 31
ASUS P3C-E User's Manual, ASUS P2T-Cable, IMPORTANT
View all Asus X900-PI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
3. HARDWARE SETUP ASUS P2T-Cable The optional ASUS P2T-Cable can be used for a Pentium® III / II processor packaged in an SECC/SECC2 or a Celeron™ processor packaged in an SEPP . Sensor Sensor Connector Plug NOTE: The ASUS P2T-Cable can only be used in a Slot 1 motherboard with a 2-pin thermal sensor connector. To Use the ASUS P2T-Cable NOTE: The following procedures assume that you have properly attached a heatsink onto an SECC/SECC2/SEPP. 1. Simply peel off the tab from the sensor and then stick the sensor near the middle edge of the Intel boxed processor heatsink with fan (middle) or to either the upper or lower edge of the Celeron™ heatsink (right), as indicated. Tab Sensor ← OR STICK ABOUT HERE WARNING! Do not insert the sensor between the processor and heatsink, otherwise, it will cause damage to the P2T-Cable. IMPORTANT! ASUS guarantees accurate readings only for the ASUS Smart Fan and the Intel boxed processor heatsink with fan because both have similar heat distribution and heatsink material. 3. H/W SETUP CPU ASUS P3C-E User's Manual 31