Asus Z97-K User Guide - Page 32
Chassis intrusion connector 4-1 pin CHASSIS, Z97-K, Chassis intrusion connector
View all Asus Z97-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
12. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS Z97-K PIN 1 Z97-K Chassis intrusion connector +5VSB_MB Chassis Signal GND 1-22 Chapter 1: Product introduction
1-22
Chapter 1: Product introduction
12.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
Z97-K
Z97-K
Chassis intrusion connector
PIN 1
+5VSB_MB
Chassis Signal
GND
CHASSIS