Audiovox AN300 Installation Guide - Page 2
Model
View all Audiovox AN300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Model AN-300 Single Amplified Windshield Mounted TV Antenna 0 0 This TV Antenna is designed to provide good reception on the difficult to receive VHF channels 2-13. Mounting Temperature should be 50 degrees or higher. 1. Clean all mounting surfaces with ammonia or alcohol. 2. Screw the telescopic elements onto the mounting base. Loosen trim above the windshield and right corner. Most corner trim are snap-in style. 3. Remove adhesive backing and mount antenna above the rear view mirror, as close as possible to the trim. On some vehicles the antenna can be placed at dash level. 4. Place small clip on each element, about 6 inches from tip. 5. Tuck cable under trim and tighten. 6. Route cable under the dash and attach to the amplifier to the amplifier input. Attach the positive and the negative leads to the 12 VDC power source. Attach amplifier to antenna input on the TV. Windshield Rear View Mirror 12 Volt DC Neg. Pos. (Black)) (Red) law Amp VIAUDIOYOX CORPORATION 128-5722