Audiovox APS2K4SBCF50 Programming Manual - Page 5

The light will turn off when the button is released. Caution! Always point the light away from you and the eyes of others. This is a bright high intensity LED which should not be directed toward or into the eyes of anyone. QUICK REFERENCE CHART: You can program any individual channel without reprogramming all channels. To go directly to a particular receiver channel follow the chart below: CHANNEL 1 Ign. On Then 2 Ign. On Then 3 Ign. On Then 4 Ign. On Then 5 Ign. On Then 6 Ign. On Then VALET SWITCH Press and Release 3 Times Press and Release 4 Times Press and Release 5 Times Press and Release 6 Times Press and Release 7 Times Press and Release 8 Times LED 1 Flash 2 Flashes 3 Flashes 4 Flashes 5 Flashes 6 Flashes BATTERY REPLACEMENT: The transmitter incorporates a small LED visible through the case which is used to indicate battery condition. You will notice a decrease in transmitter range as the battery condition deteriorates. Transmitter battery replacement is recommended at least every 10 to 12 months, depending upon how frequently the transmitter is used. To replace the battery: 1) Remove the small # 0 Phillips head screw from the rear of the case. 2) Remove the rear cover to access the discharged battery paying attention to the proper polarity orientation. 3) Carefully remove and properly dispose of the discharged battery. 4) Insert the new battery, close the case, then reinstall the small case screw removed in step 1. 5) If you accidently dislodge the cir- cuit board from the transmitter housing, be certain that the rubber mem- brane is seated properly, and the buttons are properly exposed from the front view of the case, then insert the circuit board, and return to step #4. 5 128-6516A 5 of 8