Audiovox AW822 Operation Manual - Page 8

Adjusting the Transmitter 1. Turn on your audio source (for example, A/V receiver, TV, stereo, etc.) and play music at a normal listening volume. Transmitter Back View Built-in audio input cable Transmitter power input jack Channel select switch 2. Set the channel select switch on the back of the transmitter to one of the transmitter's three broadcast frequencies: 1, 2 or 3. If you experience poor reception or interference, try choosing a different frequency by moving the channel select switch to another position. Transmitter Front View Transmission Indicator Light When the transmitter is receiving an audio signal and is ready, the light on its front turns blue. Note If the light on the front of the transmitter does not turn on, please check the following: - Confirm the transmitter AC power adapter is securely connected. - Confirm the cable from the transmitter is securely connected to the audio source output (TV, A/V receiver, etc.). Tuning the Speaker Speaker Side View Power/Tuning/ Volume Control  1. Press the ON/OFF/TUNING/VOL. control on the side of the speaker to turn it on. The STDBY./TUNED light on the front of the speaker illuminates red while the speaker is tuning to the transmitter. The STDBY./TUNED light turns blue when the speaker is tuned to the transmitter-you should hear sound coming from the speaker now. Note: If the speaker is not tuned or if the transmitter is not connected properly, the STDBY./TUNED indicator will not turn from red to blue. If this occurs, please see the troubleshooting section of this manual.