Audiovox CE270 Operating Instructions - Page 2

NAMES OF CONTROLS ADJUSTING THE SOUND VOLUME Adjust the VOLUME control of the stereo system to a desired level. For private listening Connect headphones (Ø3.5 mm stereo mini-plug) to the PHONES jack. When headphones are connected, speakers automatically disconnected. RADIO OPERATION You can listen to your favourite radio stations by sliding the FUNCTION switch to RADIO, and then 1. Slide the BAND switch to choose AM(MW) or FM. 2. Using the TUNING control to choose a desired station. • Adjust the VOLUME. AM(MW)/FM • Repositioning the unit to get better AM(MW)/FM reception. 1. Handle 13. CD display 2. CD door 3. STOP button Track number 4. PLAY / PAUSE button 5. FUNCTION switch 6. VOLUME control 7. PHONES jack 8. Fixed antenna Play " " indicator Pause " " indicator Repeat all " " indicator Repeat one " " indicator 9. Tuning control 14. BAND switch 10. SKIP button 15. AC socket 11. REPEAT button 16. Battery compartment 12. SKIP button POWERING UP AC POWER You can power your portable stereo system by plugging the detachable AC power cord into the AC inlet on the back of the unit and into a wall AC power outlet. Check that the rated voltage of your unit matches your local voltage. Make sure that the AC power cord is fully inserted into the unit. Caution: To prevent electrical shock, match wide blade of plug to wide slot, fully insert. To AC inlet To wall AC outlet BATTERY POWER Insert 6 "C" size batteries in the battery compartment. Be sure that the batteries are inserted correctly to avoid damage to the unit. • Always remove the batteries when unit will not be used for a long period of time, as this will cause leakage of the batteries and subsequently damage to your unit. • Playback would automatically come to a stop when the batteries have no more power. Replace all the batteries with new ones. • Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries. Note After listening, slide the FUNCTION switch to OFF. USING THE CD PLAYER 1. Slide the FUNCTION switch to CD. " " is shown in the display. 2. Open the CD door. Place a disc in the center with the label side up and then close the CD door gently. The total number of tracks will show in the display. 3. Press the PLAY/PAUSE button to start play. The PLAY " " indicator will light. • Adjust the VOLUME. TO STOP PLAYBACK • Press the CD STOP button to stop disc play. TO INTERRUPT PLAYBACK • Press the PLAY/PAUSE button while a CD is playing to pause play (the PAUSE " " indicator will blink). • Press the PLAY/PAUSE button again to resume play. TO SKIP TO THE BEGINNING OF A TRACK • Press either one of the SKIP or button according to the desired direction. Each press skips one track. During play, the first press on the skip backwards button to the beginning of the current track. • Playback resumes from the selected track. TO SEARCH THROUGH TRACKS • Keep either one of the SKIP or button pressed, according to the desired direction, and release at the desired point. REPEAT PLAY -- in play modes This function allows one track or all tracks on a disc to be played repeatedly. TO REPEAT THE SAME TRACK • Press the REPEAT button once during playback, the REPEAT ONE " " indicator will blink. TO REPEAT THE WHOLE DISC • Press the REPEAT button a second time to repeat all tracks, the REPEAT ALL " " indicator will light. TO CANCEL REPEAT PLAY • Press the REPEAT button until the REPEAT indicator is turned off. Note Repeat play can only be done when the unit is in the play mode.