Audiovox GMRS3082CH Owners Manual - Page 10

Gmrs3082ch Operational Modes, Controls

Page 10 highlights

GMRS3082CH OPERATIONAL MODES SCANNER BAND GMRS/FRS BAND Weather CHANNEL SELECT Weather ALERT On/Off NOTE: 1. To switch between GMRS/FRS and Weather Band modes, press and hold the MODE/WB button for 2 seconds. Refer to the appropriate section of this manual for detailed operating instructions for each mode. 2. To enter the VOX mode, press and hold the VOX button. CHANNEL SELECT CTCSS SELECT POWER SELECT (GMRS Channels Only) VOX LEVEL SELECT DUAL WATCH BUTTON BEEP ROGER BEEP CALL SELECT Controls: LED Flashlight Button (16) Press this button on the right side of the Transceiver to light the white LED (15) on top of the unit, thereby activating the built-in flashlight function. Power On-Off/SCAN Button (13) Press and hold the power on/off button ( s ) for 2 seconds. You will hear a dual beep to indicate the unit is on. Press the on/off button again for 2 seconds to turn the unit off. When the unit is on and the button is pressed momentarily, the scan mode is enabled or disabled; when enabled, the scan icon (SCAN) appears on the display. Adjusting the Volume (10, 11) With the unit powered on, press the Up Channel/Volume button ( ) to increase volume and the Down Channel/Volume button ( ) to decrease 128-8314 10 of 28 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

128-8314
10 of 28
10
GMRS3082CH OPERATIONAL MODES
SCANNER BAND
Weather CHANNEL
SELECT
ROGER
BEEP
BUTTON
BEEP
DUAL
WATCH
VOX LEVEL
SELECT
CALL
SELECT
POWER
SELECT
(GMRS Channels
Only)
GMRS/FRS BAND
CTCSS
SELECT
CHANNEL
SELECT
NOTE: 1.
To switch between GMRS/FRS
and Weather Band modes,
press and hold the MODE/WB
button for 2 seconds. Refer to
the appropriate section of this
manual for detailed operating
instructions for each mode.
2.
To enter the VOX mode,
press and hold the VOX
button.
Weather ALERT
On/Off
Controls:
LED Flashlight Button (16)
Press this button on the right side of the Transceiver to light the white LED
(15) on top of the unit, thereby activating the built-in flashlight function.
Power On-Off/SCAN Button (13)
Press and hold the power on/off button (
) for 2 seconds. You will hear
a dual beep to indicate the unit is on. Press the on/off button again for 2
seconds to turn the unit off.
When the unit is on and the button is pres-
sed momentarily,
the scan mode is enabled or disabled; when enabled,
the scan icon (
SCAN
) appears on the display.
Adjusting the Volume (10, 11)
With the unit powered on, press the Up Channel/Volume button (
) to
increase volume and the Down Channel/Volume button (
) to decrease
s