Audiovox HD5112 Operation Manual - Page 12

HD5112 Operation Power Press the (power) button (1) or any other button on the front of the radio (except release) to turn the unit on. Press and hold the power button to turn the unit off. Liquid Crystal Display (LCD) The liquid crystal display (LCD) panel (8) displays the frequency, time and activated functions of the unit, including a disc indicator, which appears lit when a disc is inserted. Press the (power) button (1) to change the LCD backlight brightness from HIGH (default) to MIDDLE to LOW. NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range. Mode Press SRC (2) to select a different mode of operation, as indicated on the display panel. Available modes include HD RADIO/TUNER (F1, F2, F3, AM1, AM2), SAT RADIO (if connected), CDP PLAY (CD), USB PLAY, SD PLAY, iPod (if connected) and AUX (auxiliary). NOTE: CDP PLAY, USB PLAY, SD PLAY, satellite radio and iPod modes are only available if the associated device or media is inserted. Audio Mute Press the MUTE button (6) to silence the audio volume. "MUTE" flashes in the display. Press any button to cancel MUTE. Volume / Audio Control To increase the volume, rotate the rotary encoder (4) clockwise. To decrease the volume, rotate the rotary encoder counter-clockwise. When volume is adjusted, the volume level will be shown on the display panel as a number ranging from "VOL 00" (lowest) to "VOL 100" (highest). Press the rotary encoder repeatedly to step through the following audio: VOLUME, BASS, TREBLE, BALANCE, and FADER. The unit automatically exits audio control mode after five seconds of inactivity. 10 11 9 1 4 5 6 8 19 20 7 21 2 TUNE / CH ENTER BAND SELECT MUTE MONO EQ iPod HD5112 A~Z PRESS 0~9 PS DISP FILE / FOLDER SRC > > AUX - IN CAT / DIR 1 2 SCN 3 RPT 4 SHF 5 6 SAT READY 3 13 12 14 15 16 17 18 22 BASS To adjust the bass level from "-10" to "10", press the rotary encoder until "BAS" appears on the display. Rotate the control clockwise to increase or counter-clockwise to decrease the bass. "00" represents a flat response. TREBLE To adjust the treble level from "-10" to "10", press the rotary encoder until "TRB" appears on the display. Rotate the control clockwise to increase or counter-clockwise to decrease the treble. "00" represents a flat response. BALANCE To adjust the balance from "10L" (full left) to "10R" (full right), press the rotary encoder until "BAL" appears on the display. Rotate the control to adjust the balance between the left and right speakers. "L=R" represents a center balance. FADER To adjust the fader from "10F" (full front) to "10R" (full rear), press the rotary encoder until "FAD" appears on the display. Rotate the control to adjust the fader between the front and rear speakers. "F=R" represents an equal balance between the front and rear speakers. 8