Audiovox PROVE8 Operation Manual - Page 17

Wired Headphones There are two 1/8" headphone jacks on the PROVE8 that can be used with any standard wired stereo headphones. These jacks are controlled by the volume up / down buttons on the PROVE8 remote control. Remove the protective plastic cover to access the jacks. Remember to replace the cover when the jacks are not in use. Wired FM Modulator The PROVE8 is equipped with an RF modulator, that allows you to listen to the PROVE8 audio signal by tuning your vehicle's radio to the selected frequency, (88.3, 88.7, 89.1, 89.5, 89.9 MHz).This feature is accessed by using the FM transmitter buttons on the remote (On/Off, Select). Whenever the RF modulator is on, broadcast reception on the vehicles radio will be poor. Switching off the FM modulator will allow normal radio reception. AV1 The video inputs may be connected to a Video cassette Player (VCP), video game system, or other audio / video devices. To access the AV1 inputs, turn the PROVE8 on and press the source button on the PROVE8 or the Source button on the remote control until "AV1" is displayed on the screen. Turn the video source component on with its power button or remote control. The PROVE8 is now ready to play the audio and video signals from the source connected to AV1 input. AUX A video game system, Camcorder or other audio/video device may be connected to the AUX input jacks (see Figure 1. for location of these jacks). To access the AUX source, turn the PROVE8 or the Source button on the remote control. The PROVE8 is now ready to play the audio and video signals from the source connected to the AUX input. IR2 Any pre-amp level (CD Changer, Satellite Radio, etc) audio source may be input into the second IR input. When using Audiovox headphones (part number IR2CHS) simply switch to channel B to listen to the source connected to the second IR input.