Audiovox PSS100 Installation Manual - Page 7

Installing the Sensor Sleeve and Sensors NOTE: When installing the sensors into the sensor sleeves, push on the outer ring of the sensor only. Never push on the center of the sensor. 1. Ensure sensors and sleeves are upright (All products have an alignment mark on the top). 2. If required, install the sensor into the sleeve. 3. Install the sensor (with sleeve if required) into the holes drilled in the bumper. 4. Run the sensor wires through the sensor sleeves in the bumper. 5. Press on the outer ring of the sensor and push until the sensor is flush with the bumper. The sensor should fit snugly into the bumper and lock into place. 6. Determine where the sensor wires will enter into the trunk area or passenger compartment. Many vehicles have a factory grommet to allow routing of wires from the outside to the inside of the vehicle. If needed, drill a hole to route the wires into the vehicle, taking care when drilling metal. Smooth edges with a round metal file and use a rubber grommet to protect the wires. 7. Feed the sensor wires through the factory grommet or other opening into the vehicle for connection to the control module (e.g., into the cab of most trucks or the trunk of passenger cars). NOTE: Once the wires are passed through, make sure there is enough wire to route to the control module. Check that the sensor wires will not be pinched by moving parts or panels. 8. Cable tie the sensor wires and the power harness wires behind the bumper, keeping them away from the exhaust system or moving suspension parts (install power harness before using cable ties). Do not pull on the sensor wires near the sensor shaft exit point, as this may damage the inner connections. 6