Audiovox RVM35 User Manual - Page 6
Wiring the Monitor, Operation - video
UPC - 044476053115
View all Audiovox RVM35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Wiring the Monitor 1. Wire the Power Cable to the vehicle's reverse lamp. a) Locate the reverse lamp in the tail light assembly. Using the tap connector supplied, perform the following steps: i. Place the un-stripped positive lead wire on the run channel. ii. Insert the un-stripped red power wire completely. iii. Fold the tap connector back over the wires and make the connection by crimping the u-contact down flush with the plastic insulator. iv. Close the top hinged cover until latched. b) Attach the black wire to the ground. i. Place the un-stripped ground lead wire on the run channel. ii. Insert the un-stripped black ground wire completely. iii. Fold the tap connector back over the wires and make the connection by crimping the u-contact down flush with the plastic insulator. iv. Close the top hinged cover until latched. c) Connect the RCA video connector from the existing camera to the monitor cable. Tap/Run Connection 5