Audiovox SCH2P User Guide - Page 21
locating the Splitter. When routing the antenna cable, be careful not to pinch, squash
UPC - 884720007200
View all Audiovox SCH2P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Cable Installation Once the antenna is mounted according to the previous instructions, you can continue with the cable portion of the installation: 1. Using one of the RG-6 cables you purchased separately, slide the rubber boot over the cable connection. Attach the cable to the antenna and slide the rubber boot over the connection to provide a weatherproof seal. Install the cable tie around the cable directly below the rubber boot to prevent the rubber boot from slipping down. Trim off the excess cable tie. (Figure 14) Figure 14 2. Route the remainder of the antenna cable into the home or building to where you are locating the Splitter. When routing the antenna cable, be careful not to pinch, squash, kink, or crimp the cable, or cut, damage, or puncture the external jacket of the antenna cable. 3. Connect the cable from the antenna to the IN port on the Splitter. (Figure 15) Note that you must use the Splitter. [ Installation ] 21