Audiovox SRSIR001FM Installation Manual - Page 12
Procedure For A Typical Bracket Installation Of The Scu
UPC - 044476009044
View all Audiovox SRSIR001FM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
PROCEDURE FOR A TYPICAL BRACKET INSTALLATION OF THE SCU (Bracket not supplied) Audiovox suggests this type of installation over the Hook & Loop type of installation though the Hook & Loop installation (if done correctly) is a secure and sufficient mounting option. Installation of the SCU using a bracket results in a professional, factory-installed look, without visibly damaging the interior of the vehicle. There are several types of brackets available to accomplish this type of installation. The installation procedure that follows, illustrates the use of a Pro.Fit® mounting bracket. Audiovox has found that the Pro.Fit® VSM® line of mounting brackets are easy to install and compliments the installation of the SCU. Pro.Fit® VSM® mounting bracket reduce the installation liability while maintaining the resale value of a car because of the professional fit, professional look and safe design. Currently Pro.Fit® VSM® offers hundreds of brackets, covering most popular cars, vans, and trucks. Step-by-step instructions and technical support are available for every mount and application. After the proper mounting bracket has been selected and installed using the Original Manufacturers installation instructions, proceed with the following steps: 1. Connect the SCU Cable to the 6 - pin Din Cable from the RRU 2. Using the Phillips Head Screws and the External Tooth Lock Washers (supplied), Mount the SCU to the bracket as shown in the Figure below. NOTE: Use caution not to over tighten the screws into the back of the SCU as this may cause damage to the unit. NOTE: Do not install the unit in the following locations: In Locations exposed to direct sunlight. Where hot air is discharged from the car heater. In areas subject to extreme temperatures. (Example installation position) AUDIO OX 1 2 3 4 5 6 7 8 9 0 SFT Phillips Round Head Screw (4mm x 8mm) External Tooth Washer (4mm int.) Bracket (Not Supplied) Bracket Shown is a PRO.FIT for ordering information visit www.pro-fit-intl.com SCU Upon completion of the SCU installation and before the SIRIUS® radio is activated a test of the system should be performed. To verify that the SRSIR-001/ SRSIR-001FM/ SRSIR-001FMR System and the SIRIUS® Antenna have been installed correctly and are functioning, select and listen to CH 184. (SIRIUS® preview channel). If there is no power to the SCU check that all connections have been made and that fuses are good. If there is no signal present, make sure that the SIRIUS® Antenna is unobstructed (move vehicle) and for SRSIR-001FM check the antenna cable connection to the FM Antenna Switch- ing Box For a detailed trouble-shooting guide, refer to the Owner's Manual. © Copyright 2002 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788 128-6375A 12