Audiovox TV3 Owners Manual - Page 3

TV3 TV3 Installing Your TV3 (continued) For Televisions with Separate 75 Ohm VHF and UHF Inputs: 1. Attach the band separator (not included) to the coaxial cable attached to the back of your TV3. 2. Screw in the VHF connector from the band separator to the VHF input on your TV or VCR. 3. Attach the 300 ohm twin wire from the band separator to the two screws marked UHF. See Fig. 2. Powering your TV3 Attach the AC adapter (included) to the DC input on the rear of your TV3. Plug the other end of the adaptor into any 12 volt AC outlet. Operating Your TERK TV3 Amplified Indoor Antenna For VHF and UHF: 1. Switch the video selector switch to "ANTENNA". 2. Tune your TV to the desired station. 3. For best results on channels 2 through 6, extend the antenna elements to their full length and horizontal positions. For channels 7 through 13, shorten the antenna elements and place at "V" angle as required. 4. Adjust the "amplification" knob for the best picture and sound. For Video Games and Other Video Components: 1. Attach the coaxial cable from your satellite, cable, or video game adapter to the video input on your TV3. Ensure a tight fit to avoid interference. 2. Switch the video selector switch to "VIDEO" for operation.To connect a DVD player, VCR or video game system to a television that is not equipped with audio/video jacks, you will need to obtain one of TERK's RF modulators. 3 VHF/UHF Fig. 1 UHF Band Separator VHF Fig. 2 4