Autodesk 46600-000000-H001 Getting Started Guide - Page 24
Add Loads
View all Autodesk 46600-000000-H001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Add Loads To simulate conditions your design can encounter, you add force loads to areas where such forces can be encountered. There are a variety of load types to use. The following list explains the available load types. Load Load-Specific Information Force Apply a force to a set of faces, edges, or vertices. When the force location is a face, the direction is automatically set to the normal of the face, with the force pointing to the inside of the part. Define the direction planar faces, straight edges, and axes. Pressure Pressure is uniform and acts normal to the surface at all locations on the surface. Apply pressure only to faces. Bearing Load Moment Apply a bearing load only to cylindrical faces. By default, the applied load is along the axis of the cylinder and the direction of the load is radial. Apply a moment only to faces. Define direction using planar faces, straight edges, two vertices, and axes. Body Loads Specifies the linear acceleration for the model using a face as input. Cylindrical selections provide an axial direction. You can only apply one body load per analysis. 18 | Chapter 2 Analyze Models