Avanti DWE1801B Instruction Manual - Page 15
Normal And Light, Normal And Quick
View all Avanti DWE1801B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Dishes are not dried Dishes and flatware not clean. used. Rinse agent dispenser is empty. Improper program. Improper rack loading. Cloudiness on glassware. Yellow or brown film on inside surfaces. Combination of soft water and too much detergent. Tea or coffee stains. Iron deposits in water can cause an overall film. White film on inside surface. Hard water minerals Detergent left in dispenser cups. Steam Dishes block detergent cups. Normal phenomenon Black or gray marks on dishes. Water standing in the bottom of the tub. Aluminum utensils have rubbed against dishes. This is normal. Water doesn't pump out of the tub. Dishwasher leaks. Drain is clogged. Overfill dispenser or rinse aid spills. Dishwasher isn't level. colorant. Make sure the rinse agent dispenser is filled. Select a stronger program. Make sure that the action for the detergent dispenser and spray arms are not blocked by large dishware. Use less detergent if you have soft water and select a shorter cycle to wash the glassware to get them clean. Using a solution of ½ cup bleach and 3 cups warm water to remove the stains by hand. Warning You have to wait for 20 minutes after a cycle to let the heating elements cool down before cleaning interior: otherwise, burns will happen. You have to call a water softener company for a special filter. To clean the interior, use a damp sponge with dishwasher detergent and wear rubber gloves. Never use any other cleaner than dishwasher detergent for the risk of foaming or suds. Re-load the dishes properly. There is some steam coming through the vent by the door latch during drying and water draining. Use a mild abrasive cleaner to eliminate those marks. A small amount of clean water around the outlet on the tub bottom at the back of the tub keeps the water seal lubricated. Make sure the kitchen sink is draining well. If the dishwasher drains into a disposer, run it clear. Be careful not to overfill the rinse aid dispenser. Spilled rinse aid could cause oversudsing and lead to overflowing. Wipe away any spills with a damp cloth. Make sure the dishwasher is level. LIGHT and QUICK program lights flicker intermittently NORMAL and LIGHT program lights flicker intermittently NORMAL and QUICK program lights flicker intermittently Water has not reached the required temperature (HOT) Failure of the temperature sensor Malfunction of the temperature sensor and or the heating element Temperature sensor has failed. Contact an authorized service center Failure of the temperature sensor Temperature sensor has failed. Contact an authorized service center 15