Home » Avanti Manuals » Ice Machines » Avanti IM12C-IS » Manual Viewer

Avanti IM12C-IS Instruction Manual - Page 9

Operating Your Ice Maker

Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

OPERATING YOUR ICE MAKER  Control Panel Description LED INDICATORS POWER INDICATOR The indicator above the word ICE will flash when the unit is plugged in. It will lit green when the unit is turned on. ADD WATER INDICATOR The ice maker automatically checks the water level in the tank. If the water level is too low, the indicator will illuminate in RED and will stop working automatically. The 'ICE' indicator will flash.Once you add water to the unit and push the ON/OFF button the indicator will turn off and will resume normal operation. ICE FULL INDICATOR When the ice-bin is full, the indicator will illuminate in RED. The indicator will remain lit until the ice in the bin either melts away slowly or has been removed. The unit will stay in a "Standby" mode until the ice has been removed / melted at which time the unit will automatically start operation as normal. Operating Instructions Starting your Ice maker • Open the top cover and remove the ice basket. • Remove any dust or objects that may be in the water tank • Fill the water tank up to the area marked "MAX". • The ice-maker will automatically check the water level in the reservoir periodically. The ice maker will detect any shortage of water and will stop the ice-making cycle, then the ADD WATER indicator will be lit. • Fill the reservoir with water and press the ON/OFF button to restart the ice-making cycle and the ADD WATER indicator goes out as the ice-maker will begin it's normal operation cycle automatically. • When the ice cubes are collected and reach the bin sensor, the ice maker will stop operating and the ICE FULL indicator will be lit. • WARNING: Direct sunlight may affect the infrared sensors and cause the unit to malfunction. If at any time the unit does not stop the ice-making operation even when the ice-bin is full, move the unit to another location where it is out of direct sunlight. • For best performance, water temperature should be between 7°C (45ºF) and 35°C (95ºF) and ambient between 15°C (59ºF) and 25°C (77ºF). Getting Ice from the Ice-bin • Open the top cover to access the ice basket. • Remove the amount of ice as desired and close the top. 9

Section	Page
Help us help you…	5
PARTS AND FEATURES	6
Silicon Drain Plug	6
1	6
Water Tank	6
2	6
Compressor	6
3	6
Power Plug	6
4	6
Top Lid	6
5	6
Top Window	6
6	6
Back Cover	6
7	6
Control Panel	6
8	6
Water Tray	6
9	6
Evaporator	6
10	6
Ice Scoop	6
11	6
Ice Basket	6
12	6
IMPORTANT SAFETY INSTRUCTIONS	7
INSTALLATION INSTRUCTIONS	7
 Before Using Your Ice Maker	7
 Installation Of Your Ice Maker	7
 Electrical Connection	8
 Extension Cord	8
 surge protector	8
OPERATING YOUR ICE MAKER	9
CARE AND MAINTENANCE	10
 Cleaning Your Ice Maker	10
 To ensure the cleanliness of the ice cubes, water in the reservoir should be replaced every 24 hours.	10
 Remove the drain plug to drain remaining water from the water reservoir when the ice maker will not be used for long period of time. Screw the drain plug back in place after the water has been drained.	10
 Always change with fresh water before starting ice production at initial installation or after long shut-off periods.	10
 Please clean your Ice maker regularly. When cleaning, unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not spray Ice maker with chemicals or dilute...	10
 Space Requirements	10
 During transportation, the incline angle of the cabinet should not be over 45	10
 Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed system.	10
 The Ice maker should be placed horizontally on a properly leveled surface.	10
 To ensure proper ventilation for your Ice maker allow 6” of space at the top, the back and on each side.	10
 Before using the Ice maker for the first time, please wait 2 hours after positioning it.	10
 Clean the inner liner, ice-bin, water box, water cup frequently.	10
 Power Failure	10
TROUBLESHOOTING GUIDE	11
Service For Your Ice Maker	11
MEDIDAS DE PRECAUCION IMPORTANTES	13
INSTRUCCIONES DE INSTALACION	13
 Antes de usar su Máquina de Hacer Hielo	13
 Instalación de su máquina de hacer hielo	13
 Conexión Eléctrica	14
 Cable de Extensión	14
 Protector contra variaciones de corriente eléctrica (Surge Protector).	14
OPERANDO SU MÁQUINA DE HACER HIELO	15
CUIDADO Y MANTENIMIENTO	16
 Limpiando su máquina de hacer hielo	16
 Para asegurar la higiene en los cubos de hielo, el agua del tanque debe ser reemplazada cada 24 horas.	16
 Cuando la máquina de hacer hielo no sea usada por un largo período de tiempo, retire el tapón del drenaje para que el agua remanente del tanque sea descartada. Coloque el tapón del drenaje nuevamente en su sitio después que toda el agua haya sido d...	16
 Siempre use agua fresca antes de empezar la producción de hielo durante la instalación inicial o después de largos períodos de inactividad.	16
 Por favor limpie su máquina de hacer hielo regularmente. Cuando la limpie, desconecte la unidad de la electricidad y retire los cubos de hielo. Use una solución diluída de agua y vinagre para limpiar el interior y el exterior de la superficie de l...	16
 Requerimientos de espacio	16
 El ángulo de inclinación de la unidad durante el transporte no debe exceder los 45	16
 No ponga la máquina de hacer hielo de cabeza ya que esto puede producir problemas en el compresor y el sistema sellado.	16
 La máquina de hacer hielo debe ser colocada sobre una superficie correctamente nivelada.	16
 Para asegurar ventilación apropiada para su máquina de hacer hielo, deje 6” de espacio encima de la superficie, la parte posterior y los lados.	16
 Antes de usar la máquina de hacer hielo por primera vez, por favor espere 2 horas después de colocarla en su posición final.	16
 Limpie la superficie interna, el contenedor del hielo, el tanque de agua y el reservorio para rellenar el tanque de agua con mucha frecuencia.	16
 Falta de electricidad	16
GUIA PARA RESOLVER PROBLEMAS	17

Match case Limit results 1 per page

OPERATING YOUR ICE MAKER



Control Panel Description

LED INDICATORS

POWER INDICATOR

The indicator above the word ICE will flash when the unit is plugged in.

It will lit green when the unit is turned on.

ADD WATER INDICATOR

The ice maker automatically checks the

water level in the tank.

If the water level

is too low, the indicator will illuminate in

RED and will stop working automatically.

The ‘ICE’ indicator will flash.

Once you

add water to the unit

and push the

ON/OFF button

the indicator will turn off

and will resume normal operation.

ICE FULL INDICATOR

When the ice-bin is full, the indicator will illuminate in RED.

The indicator will remain lit until the ice

in the bin either melts away slowly or has been removed.

The unit will stay in a “Standby” mode

until the ice has been removed / melted at which time the unit will automatically start operation as

normal.

Operating Instructions

Starting your Ice maker

•

Open the top cover and remove the ice basket.

•

Remove any dust or objects that may be in the water tank

•

Fill the water tank up to the area marked “MAX”.

•

The ice-maker will automatically check the water level in the

reservoir periodically. The ice maker will detect any shortage

of water and will stop the ice-making cycle, then the ADD

WATER indicator will be lit.

•

Fill the reservoir with water and press the ON/OFF button to

restart the ice-making cycle and the ADD WATER indicator

goes out as the ice-maker will begin it’s normal operation cycle automatically.

•

When the ice cubes are collected and reach the bin sensor, the ice maker will stop

operating and the ICE FULL indicator will be lit.

•

WARNING:

Direct sunlight may affect the infrared sensors and cause the unit to malfunction.

If at any time the unit does not stop the ice-making operation even when the ice-bin is full, move the

unit to another location where it is out of direct sunlight.

•

For best performance, water temperature should be between 7

C (45ºF) and 35

C (95ºF)

and ambient between 15

C (59ºF) and 25

C (77ºF).

Getting Ice from the Ice-bin

•

Open the top cover to access the ice basket.

•

Remove the amount of ice as desired and close the top.