Avanti WD360 Instruction Manual - Page 6
water dispenser
View all Avanti WD360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Important Safety Instructions wARNING# To reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions: • Read all instructions before using the water dispenser. • Never clean parts with flammable fluids. The fumes can create a fire hazard or explosion. • Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or any other water dispenser. The fumes can create a fire hazard or explosion • Do not plug unit into receptacle until you ensure the water tank switches are off. -Save these instructions- INSTALLATION GUIDELINES: • Remove the exterior and interior packing. • Place your appliance on a floor that is strong enough to support the dispenser when it is fully loaded. If it does not sit level on the floor, adjust the front right foot to level the unit well to the floor. Note: Only the front right foot is adjustable. • Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not to perform properly. • Allow 2 inches of space between the water dispenser and the wall, which allows the proper air circulation to cool the compressor. • Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. • This water dispenser is not recommended for outdoor use. • Do not locate the dispenser in area where the temperature may fall below freezing (32° F). • Keep area around dispenser free of dust and dirt. • Keep the reserve supply of water bottles away from excessive heat and light. • Never unplug the water cooler, except for maintenance. OPERATION INSTRUCTIONS: Before Using Your Water Dispenser • Check to be sure the following parts are included: • 4 Extra Cup Dispenser Cabinet Plugs • Accessories Order Form. • Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows: • Keep the unit unplugged.