Avanti ZJ003-IS Instruction Manual - Page 9

Filling The Filter Bottle With Tap Water

Get Avanti ZJ003-IS PDF manuals and user guides View all Avanti ZJ003-IS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

USE AND CARE 7 FILLING THE FILTER BOTTLE WITH TAP WATER 1. Remove lid. 2. S lowly fill the upper reservoir with cold tap water. Be careful not to dump water too quickly into the upper chamber when the lower chamber is empty because it may tip and spill. 3. Allow water to pass from the upper chamber through the filters to the lower chamber. Water will be ready to drink in several minutes. 4. Test the water using the TDS meter to confirm a "000" reading. 5. If it doesn't read "000", flush the water out, check all connections and seals. 6. Pour water through. 7. Do not over fill. The first time you fill your Filter Bottle it will take extra water to fill the cooler reservoir. When water in the lower chamber reaches the line marked "MAXIMUM WATER LEVEL", do not put any more water in the upper chamber, as it may leak. The upper chamber is not designed to be a long term reservoir. Safety Precautions: Do not use with water that is microbiologically unsafe or of unknown quality without proper disinfection before or after the system. Individuals requiring water of specific microbiological purity should consult their physician. Unless notified otherwise, municipal water is potable.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
USE AND CARE
7
FILLING THE FILTER BOTTLE WITH TAP WATER
1. Remove lid.
2. Slowly fill the upper reservoir with cold tap water. Be careful not to dump
water too quickly into the upper chamber when the lower chamber is
empty because
it may tip and spill.
3. Allow water to pass from the upper chamber through the filters to the
lower chamber. Water will be ready to drink in several minutes.
4. Test the water using the TDS meter to confirm a “000” reading.
5. If it doesn’t read “000”, flush the water out, check all connections and
seals.
6. Pour water through.
7. Do not over fill. The first time you fill your Filter Bottle it will take extra
water to fill the cooler reservoir. When water in the lower chamber
reaches the line marked “MAXIMUM WATER LEVEL”,
do not put any
more water in the upper chamber, as it may leak. The upper chamber is
not designed to be a long term reservoir.
Safety Precautions:
Do not use with water that is microbiologically unsafe
or of unknown quality without proper disinfection before or after the
system. Individuals requiring water of specific microbiological purity should
consult their physician. Unless notified otherwise, municipal water is
potable.