Axis Communications 240Q 240Q User's Manual - Page 6

6 AXIS 240Q - Product Description AXIS 240Q Front Panel Indicators - After completion of the startup and self-test routines, the multi-colored Network, Status, Power Indicators flash as follows: Network Status Power Unlit Green Amber Unlit Green Amber Red Green Amber No connection. Steady for connection to a 100 Mbit/s network. Flashes for network activity. Steady for connection to a 10 Mbit/s network. Flashes for network activity. When configured for "no flash" on camera access. Steady for normal operation. Can be configured to flash green at intervals whenever the camera is accessed. See the online help for more information. Steady during startup, reset to factory default or when restoring settings. Slow flash for failed upgrade. Normal operation. Flashes green/amber during firmware upgrade. DIP Switches - A corresponding line termination switch for each of the supported video inputs. All units are shipped with the line termination enabled for each video input; that is, with the DIP switches set in the down position. Note: If the AXIS 240Q is to be connected in parallel with other equipment, disable the input termination by turning the corresponding DIP switch to the up position (OFF). Failure to do so may impair the image quality. Control Button - Press this button to restore the factory default settings, as described in Resetting to the Factory Default Settings, on page 44, or to install using AXIS Internet Dynamic DNS Service (page 15). Video Inputs - Accommodates up to 4 separate video sources (VIDEO 1 - VIDEO 4) simultaneously. Each supported video input is connected using a coax/BNC connector. Physical connections made using e.g. 75 Ohm coax video cable have a recommended maximum length of 800 feet (250 meters).