Behringer ADA8200 Quick Start Guide - Page 6
ULTRAGAIN DIGITAL ADA8200 Controls
View all Behringer ADA8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
10 ULTRAGAIN DIGITAL ADA8200 ULTRAGAIN DIGITAL ADA8200 Controls (1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) 11 Quick Start Guide (EN) Step 2: Controls (1) SIG LED indicates an input signal. This LED (12) 8-CHANNEL DIGITAL I/O ADAT IN sends illuminates when an audio signal is present 8 channels of digital audio input from an at one of the inputs. ADAT device to the 8 analog line outputs. (2) CLIP LED indicates the input signal level is too high. This LED illuminates when the This input connects to other ADAT devices via TOSLINK cable. audio signal peaks in the channel. Adjust the (13) Word Clock Input connects to external gain knob to reduce the signal level and devices for word clock synchronization. avoid clipping. This BNC connector is only active when (3) MIC IN connects XLR microphone or instrument input to Midas designed preamplifiers. the SYNC selector (see 14) is switched to SLAVE > WC IN. All devices within the system (i.e. digital mixer, digital recorder, or computer recording interface) must be (4) GAIN knob adjusts the channel input level. synchronized via a shared word clock signal. The gain knob adjusts the input level for either the MIC IN or LINE IN connection. (14) SYNC (Word clock settings selector) designates internal or external word clock (5) LINE IN connects ¼" TRS input at line level. configuration and sample rate. If the (6) SYNC MASTER LED indicates that the ADA8200 is the master word clock source. External word clock devices receive their sync signal from the ADA8200. ADA8200 is slaved to an external word clock source, select either WC IN or ADAT IN according to your word clock connection. If the ADA8200 is functioning as the master word clock source for external ADAT (7) SYNC LOCKED LED illuminates when the devices, select the appropriate sample rate ADA8200 is the master word clock source, (either 44.1 or 48 kHz). or when receiving a valid sync signal from an external word clock source (via either ADAT or word clock in). (15) LINE OUT XLR male connectors send D/A converted audio output from ADAT IN connector. (8) PHANTOM POWER +48 V switches the +48 V phantom power on and off. Phantom power is active on all MIC IN inputs when engaged. (9) ON/OFF POWER switch turns the ADA8200 on and off. (10) Power is supplied via an IEC cable connected to the mains. An IEC cable is provided. (11) 8-CHANNEL DIGITAL I/O ADAT OUT sends 8 channels of digital audio output from the analog inputs to an ADAT device. This output connects to other ADAT devices via TOSLINK cable.