Behringer EURORACK UB2442FX-PRO Manual - Page 8
Stereo channels - 16
View all Behringer EURORACK UB2442FX-PRO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
8 EURORACK UB2442FX-PRO/UB2222FX-PRO/UB1832FX-PRO/UB1622FX-PRO User Manual 2.1.4 Routing switch, PAN, SOLO and channel fader SUB (1-2 and 3-4) The SUB switch routes the signal to the corresponding subgroups. The UB2442FX-PRO has 4 subgroups (1-2 and 3-4). MAIN The MAIN switch routes the signal to the main mix bus. The channel fader determines the channel's volume in the main mix (or submix). 2.2 Stereo channels 2.2.1 Channel inputs UB2442FX-PRO Fig. 2.4: The panorama and routing controls and the channel fader PAN The PAN control determines the position of the channel signal within the stereo image. When working with subgroups, you can use the PAN control to assign the signal to just one output, which gives you additional flexibility in recording situations. For example, when routing to subgroups 3 and 4, panning hard left will route the signal to group output 3 only, and panning hard right will route to group output 4 only. MUTE The MUTE switch breaks the signal path pre-channel fader, hence muting that channel in the main mix. The aux sends which are set to post-fader are likewise muted for that channel, while the pre-fader monitor paths remain active irrespective of whether the channel is muted or not. MUTE LED The MUTE LED indicates a muted channel. CLIP-LED The CLIP-LED lights up when the input signal is driven too high. If this happens, back off the GAIN control and, if necessary, check the setting of the channel EQ. SOLO The SOLO switch is used to route the channel signal to the solo bus (Solo In Place) or to the PFL bus (Pre Fader Listen). This enables you to listen to a channel signal without affecting the main output signal. The signal you hear is taken either before the pan control (PFL, mono) or after the pan and channel fader (Solo, stereo) (cf. chap. 2.3.10 "Level meters and monitoring"). UB2222FX-PRO UB2442FX-PRO Fig. 2.5: The various stereo channel inputs UB2442FX-PRO Each stereo channel has two balanced line level inputs on jacks for left and right channels. Channels 9/10 and 11/12 on the UB2442FX-PRO feature an additional XLR microphone jack with phantom power. If only the left jack (marked "L") is used, the channel operates in mono. The stereo channels are designed to handle typical line level signals, and, depending on model, have a level switch (+4 dBu or -10 dBV) and/or a line GAIN control. Both jack inputs will also accept unbalanced connectors. LOW CUT and MIC GAIN These two control elements operate on the XLR connectors of the UB2442FX-PRO, and are used to filter out frequencies below 75 Hz (LOW CUT) and to adjust microphone levels (MIC GAIN). LINE GAIN Use this control to adjust the line signal levels on channels 13-16 (UB2442FX-PRO only).