Behringer FCA202 Manual - Page 9

9 F-CONTROL AUDIO FCA202 User Manual • When the installation has been successfully completed, connect the hardware interface with the computer via an unused FireWire socket. The hardware inputs and outputs are now available to you in every audio application ◊ During the installation process, you may be given a Windows message that the equipment drivers that are to be installed have not passed the Windows Logo test. Confirm this message and proceed as usual with the installation. Your Windows installation will not be affected by this in any way 2.3 Installation under Mac OS X With the Mac OS X, you can use the FCA202 immediately, without having to install additional drivers. Connect the hardware to your Mac via an unused FireWire socket. OS X (from version 10.3.9) will automatically recognize the equipment. The inputs and outputs on the interface are now available to you in every audio application. 2.4 Hardware connection Connect the FCA202 to your computer using one of the two FireWire cables provided. Some computers have 6-pin sockets which allow the power supply for the FireWire hardware to be made directly via the bus, while others offer reduced 4-pin sockets. Depending on the arrangement, there are various ways in which you can operate your FCA202. • Operation without a mains adapter on a computer with a 6-pin socket This is a typical setup for most computers, which can provide adequate power supply for the FCA202 via the FireWire interface. Use the appropriate cable with the 6-pin plug connectors. If your computer cannot ensure an adequate power supply, use the mains adapter that is provided.