Behringer HPA40 Quick Start Guide - Page 5
EUROPORT HPA40 Controls
View all Behringer HPA40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
8 EUROPORT HPA40 EUROPORT HPA40 Controls (3) (2) (3) (4) (7) (8) (6) (9) (10) (5) (12) (1) (11) 9 Quick Start Guide (EN) Controls (1) LOUDSPEAKER. (10) Connect to the power supply via the The device's SERIAL NUMBER (2) CARRY HANDLE. polarized DC IN connector. A fitting power adapter is supplied. Use the is found on the bottom side of the unit. (3) HOLES FOR SHOULDER STRAP. (4) The rotary MIC LEVEL control allows you to adjust the volume level. device only with the included power supply. (11) COMPARTMENT FOR BATTERY AND SHOULDER STRAP. To insert the battery, open the (12) DIGITAL WIRELESS USB input accepts the optional BEHRINGER ULM wireless microphone receiver. The LED indicates wireless microphone signal input. (5) POWER switch turns the device on compartment's cover. The bottom and off. When turned on, the LED of half of the compartment is used the POWER switch lights up. for the battery. Open the latch to (6) LOW BAT LED indicates that the rechargeable battery needs to be charged. access the battery compartment. Insert the battery as follows: The terminals must face the device with the positive terminal (red) (7) CHARGE LED flashes yellow as long as the rechargeable battery is charging. It goes out when the battery is fully charged. on the side of the HPA40 control panel (to the left, as seen from the rear panel). Insert the battery and close the latch. Close the battery compartment. (8) Connect the supplied BEHRINGER XM1800S microphone to the MIC IN input. NOTE: The HPA40 ships with a rechargeable internal battery that can power continuous ◊ Never hold the microphone audio playback for up to 8 hours. directly in front of the We recommend that you fully loudspeaker. Feedback hazard! charge the battery before your first When operating the device, use. See the "Charging the battery" keep the microphone behind the section for more information. loudspeaker to avoid feedback. (9) You can connect an external sound source (CD player, MP3 player, etc.) to the LINE IN input. Charging the battery The HPA40 ships with a rechargeable, internal battery that can power continuous audio playback for up to 8 hours. We recommend that you fully charge the battery before your first use. To charge the battery for the first time, follow this procedure: 1. Turn off the HPA40 by pressing the POWER switch. 2. Connect the unit to an AC power outlet. The CHARGE LED will light to indicate the battery is charging. 3. Keep the unit plugged in to AC power until the CHARGE LED indicates the battery has been fully charged. NOTE: The HPA40 uses a sealed lead-acid gel battery, and the battery will slowly self-discharge when the HPA40 is not in use. Before storing the HPA40 for an extended period, fully charge the battery before storage, and then charge again every 3 months. NOTE: The lead-acid battery needs to be recharged every 3 months for continued operation. Please replace the battery if the HPA40 operating time noticeably decreases, even after a full charge cycle.