Behringer STUDIO CONDENSER MICROPHONES C-2 Manual - Page 5
Low Cut-Filter and Signal Level, Attenuation -10 dB, Microphone Installation, Audio Connection, - manual
View all Behringer STUDIO CONDENSER MICROPHONES C-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
21 STUDIO CONDENSER MICROPHONES C-2 User Manual Of course, you can use your microphones individually as well. A cardioid pattern capsule is often used in recording situations in which several sound sources are present. Since this capsule selectively tones down the pickup of sounds located to the side of the microphone, this way you can achieve good separation of sound sources, thus easily avoiding feedback. 5. Low Cut-Filter and Signal Level Attenuation (-10 dB) The C‑2 studio microphones feature a switchable low-cut filter that lets you eliminate low-frequency disturbances such as subsonic noise. Set the switch to its middle position to activate the low-cut filter. A switchable level attenuation is provided on your C‑2s for applications in which the microphones are exposed to extremely high sound pressures. When the switch is in its "−10 dB" position, the level attenuation is activated. When the switch is in its top-most position, the signal is not influenced in any way. 6. Microphone Installation To attach the microphones to the microphone stands, two clamps are included with the delivery. First screw a clamp onto the stand before attacting the microphone itself. 7. Audio Connection Use a balanced XLR microphone cable with the following pin assignment: pin 1 = shielding; pin 2 = +; pin 3 = -. Since your C‑2 features gold-plated contact points throughout, we recommend that you use only microphone cables with gold-plated connectors. 8. Level Setting/Adjusting the Basic Sound Adjust the gain control in the microphone channel of your mixing console so that the peak LED lights up only occasionally or never at all. The EQ controls in the microphone channel should be set to mid-travel position to start with; low-cut filter and signal level attenunation should be switched off. To get the sound you want, try changing the mic position relative to the sound source or even move the microphone around in the recording room of your studio. Adjusting the angle at which walls face the sound source can also be helpful. Only when the desired basic sound has been achieved, should you start to use equalizers and signal processors, if any at all. Remember: less is often more!