Behringer XENYX UFX1604 Quick Start Guide - Page 15
XENYX UFX1604 Getting started - full guide
View all Behringer XENYX UFX1604 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
28 XENYX UFX1604 XENYX UFX1604 Getting started (EN) Step 3: Getting started Make sure the power to all devices is turned off. Connect all appropriate power, audio and FireWire/USB cables to the mixer. Set all faders to the down position, PAN/BAL knobs centered and all other knobs (except EQ) all the way left. Turn the mixer on. Adjust the left-right position of a channel in the stereo field if necessary by turning the channel's PAN or BAL knob. 29 Quick Start Guide For live applications, adjust the overall output from the mixer to the power amp or powered speakers by raising the MAIN MIX fader. If the CLIP LEDs on the VU METER light, lower the MAIN MIX fader. Use the channel AUX knobs and master AUX SEND knobs to send the channel signals to an effects processor or stage monitor connected to the AUX SEND jacks. If used for effects, route the signal back from the processor to the AUX RETURN jacks. With the MAIN MIX fader, PHONES, CONTROL RM, and ALT 3-4 knobs all the way down, turn your PA system or powered monitors on. Slowly raise the MAIN MIX fader, PHONES, CONTROL RM and ALT 3-4 knobs to 0 or the desired level. Adjust the level of connected microphones and instruments by raising each CHANNEL FADER. Adjust the COMP knob to add compression to an input if necessary. EUROLIVE F1320D active oor monitor VIRTUALIZER 3D FX2000