Beko ASP341 User Manual - Page 8

3 Installation Always have the repair procedures carried out by 3.1. Appropriate the Authorised Service Agent. Manufacturer shall installation location not be held liable for damages that may arise from procedures carried out by unauthorised persons. To make the product ready for use, make sure that the electricity installation is appropriate before calling the Authorised Service Agent. If not, call WARNING: If the door of the room where A the product will be placed is too small for the product to pass, then the product's doors can be removed and the product turned aside to pass it through. a qualified electrician to have any necessary arrangements carried out. • Choose a place at where you would use the product comfortably. C B Preparation of the location and electrical • Install the product at least 30 cm away from installation at the place of installation is heat sources such as hobs, ovens, heater cores under customer's responsibility. and stoves. Product must not be subjected to direct sun light and kept in humid places after Product must not be plugged in during installation. installation. Otherwise, there is the risk of death or serious injury! • Appropriate air ventilation must be provided around your product in order to achieve an B WARNING: Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised persons. efficient operation. If the product is to be placed in a recess in the wall, pay attention to leave at least 5 cm distance with the ceiling and side walls. A C WARNING: Prior to installation, visually • Do not place the product on the materials such check if the product has any defects on as rugs or carpets. it. If so, do not have it installed. Damaged • Place the product on an even floor surface to products cause risks for your safety. prevent jolts. Make sure that the power cable is not • Do not install the product in places where the pinched or crushed while pushing the product into its place after installation or cleaning procedures. temperature falls below 5°C. C If two coolers are to be installed side by side, there should be at least 4 cm distance between them. 3.2. Installing the plastic wedges Plastic wedges are used to create the distance for the air circulation between the product and the rear wall. Insert the 2 plastic wedges onto the rear ventilation cover as illustrated in the figure. To install the wedges, remove the screws on the product and use the screws given in the same pouch with the wedges. Refrigerator / User Manual 7 / 30 EN