Beko CEG3190B Owners Manual - Page 26

6 Troubleshooting Problem Cause Solution The appliance does not work. The appliance is not connected Plug in and press the switch. to the mains. Check the cable and the Plug No or delayed response in several trials of pressing on function key on the panel Appliance is under an electromagnetic interference Dirt over the panel Unplug the appliance. Restart after few minutes Clean the panel with the cloth provided The coffee is not hot enough. The cups have not been Rinse the appliance at least preheated. 3 times before making the The brewing unit is too cold. coffee. The coffee cannot come out Empty system function maybe Press the hot water button from spout. used before. until water can come out from spout. The first cup of coffee is poor quality. The first run of grinder does not pour sufficient quantity coffee power into the brewing unit. Throw the coffee away. The other coffees will always be of good quality. Coffee has no cream. Not pressing the touch button from the front direction of the appliance Press the lower bottom part of the icon of the touch button from the front direction of the appliance. The touch buttons are not sensitive Excessive scale has built up. Descale the appliance. The water tank is removed / the water level is very low in the water tank but have no alert. The area near the water tank connector is wet. Wipe the water around the water tank connector Internal drip tray is filled with a Coffee powder too fine which Adjust the coffee fineness lot of water. block the water to come out. to bigger dot during grinder operation. Coffee is delivered too slowly Coffee powder too fine which Adjust the coffee fineness or a drop at a time. block the water to come out. to bigger dot during grinder operation. Lack of bean indicator flashes Internal coffee powder outlet To follow the steps of section but there is still a lot of coffee is blocked. E (V. Cleaning coffee powder bean inside the container. outlet). 26 / EN Fully Automatic Coffee Maker / User Manual