Beko CIHV21 User Manual - Page 11
Danger
View all Beko CIHV21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
"DANGER: I The product must be connected to the mains • supply only by an authorised and qualified person. The product's warranty period starts only after correct installation. Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. ▪ DANGER: JJJI The power cable must not be clamped, bent or • trapped or come into contact with hot parts of the product. A damaged power cable must be replaced by a qualified electrician. Otherwise, there is risk of electric shock, short circuit or fire! • Connection must comply with national regulations. • The mains supply data must correspond to the data specified on the type label of the product. Type label is at the rear housing of the product. • Power cable of your product must comply with the values in "Technical specifications" table. yi\ DANGER: Before starting any work on the electrical installation, disconnect the product from the mains supply. There is the risk of electric shock! Connecting the power cable 1. If a power cable is not supplied together with your product, a power cable that you would select from the table in accordance with the electrical installation at your home must be connected to your product by following the instructions in cable diagram. This product must only be connected by a qualified electrician such as a technician from the local electricity company or NICEIC registered contractor to a suitable double-pole control unit with a minimum contact clearance of 3 mm in all poles. This control unit must be installed accordance with the IEE regulation. Failure to obey this instruction may cause operational problems and invalidate the product warranty. dditional protection by a residual current rcuit breaker is recommended. with the integrated screw on cable clamping component. 4. Connect the cables according to the supplied diagram. opper bridge UP CORD PTA, COP 5)(1..5mm 400V2N - 5X1.5mm 230V 3)(2.5mm 230V - 5. After completing the wire connections, close the terminal block cover. 6. Route the power cable so that it will not contact the product and get squeezed between the product and the wall. Power cable must not be longer than 2 m because of safety reasons. Installing the product 1. Turning the hob upside down, place it on a flat surface. 2. The sealing gasket provided in the package must be applied on the lower casing bend around the hob as shown in the figure, during installation of the hob. • 3. Place the hob on the counter and align it. 4. Using the installation clamps secure the hob by fitting throat] the holes on the lower casing 2. Open the terminal block cover with a screwdriver 3. Insert the power cable through the cable clamp below the terminal and secure it to the main body 11/EN