Beko DCU6130 User Manual - Page 20

7 Maintenance and cleaning Filter Cartridge / Door Inner Surface Lint and fibres released from the laundry to the air during the drying cycle are collected in the "Filter Cartridge". CSuch fibre and lint are generally formed during wearing and washing. C Always clean the filter and the inner surfaces of the cover after each drying process. C You can clean the filter and filter area by vacuum cleaner. To clean the filter: 1. Open the loading door. 2. Remove the cover filter by pulling it up and open the filter. 3. Clean lint, fibre, and cotton by unravelling by hand or with a soft piece of cloth. 4. Close the filter and place it back into its seat. C Clogging may arise on the filter surface after using your machine for some time; if this occurs, wash the filter with water and dry it before using again. C Clean the entire inner surface of the door and door gasket by wiping with a damp cloth. Sensor There are humidity sensors in your dryer that detect whether the laundry is dry or not. To clean the sensor: 1. Open the loading door of the dryer. 2. Allow the machine to cool down if drying has been carried out. 3. Wipe the metal sensors with a soft cloth, dampened with vinegar and dry them. C Clean metal sensors 4 times a year. A Never use solvents, cleaning agents or similar substances when cleaning since these materials can cause fire and explosion! Water tank; The moisture in the damp laundry is taken from the laundry and condensed. Drain the water tank after each drying cycle or during drying when "Water tank" warning light turns on. 20 EN