Beko DFN15X10 User Manual - Page 16

Preparation Test Strip a b c 1 second d e f Level 1 Level 2 Level 3 1 minute Level 4 Level 5 Level 6 No Lime Very low lime content Low lime content Medium lime content High lime content Very High lime content Remove the Let the water Fill a glass with test strip from flow from your tap water and its packing. tap for 1 minute. dip the test strip into water for 1 second. Take the test strip out of the water and shake it. Hold for Set the water hardness level of your dishwasher 1 minute. according to the result shown by the test strip. To Adjust the Water Hardness 1. After turning on the machine, press and hold Time Delay and Programme keys simultaneously for 3 seconds to enter the settings menu. 2. Press the programme key until the Salt indicator starts to flash. Current regeneration stage is displayed on the programme indicator. 3. Using Time Delay key, adjust water hardness level according to the hardness of the supply water. See "Water hardness level adjustment table" for correct setting. 4. Press On / Off key to save the setting. Water Hardness Level Adjustment Table Hardness Level 1st Level 2nd Level English Water Hardness °dE German Water Hardness °dH French Water Hardness °dF* Position of Regeneration Adjustment Switch** Water Hardness Level Indicator 0-5 0-4 0-8 6-9 5-7 9-13 Press the Time Delay key to switch the water hardness level to position P1. ** Regeneration Adjustment Switch 3rd Level 4th Level 5th Level 6th Level 10-15 8-12 14-22 16-19 13-15 23-27 20-24 16-19 28-34 25-62 20-50 35-90 Press the Time Delay key to switch the water hardness level to position P2. Press the Time Delay key to switch the water hardness level to position P3. Press the Time Delay key to switch the water hardness level to position P4. Press the Time Delay key to switch the water hardness level to position P5. Perform the same hardness level adjustment that you have set on the control panel also with the regeneration adjustment switch. For example, if you have adjusted to "3" in the control panel, also set the regeneration adjustment switch to 3. If the hardness level of the water that you use is above 90°dF (French standard for water hardness) or if you are using well water, than it is recommended to use filter and water purification devices. * If the hardness level of the water that you use is below 8°dF (French standard for water hardness), there is no need to use salt in your dishwasher. If this is the case, Salt Indicator (if any) illuminates continuously on the panel of your machine. If the water hardness is set to level 1, the Salt Indicator will illuminate continuously although it is not necessary to use salt. If you use salt under this condition, salt will not be consumed and the lamp will not illuminate. 14 /39 EN Dishwasher / User's Manual