Beko DFN16X21 Owners Manual - Page 34
Salt indicator, Rinse Aid indicator, Adjusting the amount of rinse, End of programme, Water cut-off
View all Beko DFN16X21 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
There might be residues of detergent or rinse aid in the machine and/or on the pieces being washed depending on the step the programme you have cancelled was in. Salt indicator ( ) Please check the salt indicator on the display to see whether there is adequate amount of softening salt in the dishwasher or not. You need to refill the salt reservoir with salt whenever salt indicator appears on the display of your machine. Adjusting the water hardness level is explained in Water Softening System section. Rinse Aid indicator ( ) Please check the rinse aid indicator on the display to see whether there is adequate amount of rinse aid in the dishwasher or not. You need to refill the rinse aid reservoir with rinse aid whenever rinse aid indicator appears on the display of your machine. Adjusting the amount of rinse aid 1. After turning on the machine, press and hold Time Delay and P keys simultaneously for 3 seconds to enter the settings menu. 2. Press P key until the drying indicator starts flashing 3. Set to the appropriate level with the Time Delay key. 4. Press the On/Off key to save. No rinse aid dispensed in P:1 position 1 dose of rinse aid is dispensed in P:2 position. 2 doses of rinse aid are dispensed in P:3 position. 3 doses of rinse aid are dispensed in P:4 position. 34/EN 4 doses of rinse aid are dispensed in P:5 position. End of programme End of Programme indicator will light up once the washing programme is over. 1. Press the On/Off key to turn off your machine. 2. Close the tap. 3. Unplug the machine from the socket. For energy saving, the machine is automatically turned off following the completion of the programme or if the programme is not started. Leave your dishes in the machine for about 15 minutes to allow them cool down after they are washed. Your dishes will dry in a shorter time if you leave the door of your machine ajar during this period. This process will increase the drying effectiveness of your machine. Water cut-off warning If mains water is cut or water inlet tap is turned off the machine cannot take water in and P2 icon will flash on the programme indicator. As long as the problem continues, washing programme is paused and the water inlet is checked regularly by the machine; when the water is restored P2 icon will disappear after a while and the washing programme resumes. Overflowing warning If the machine intakes too much water or there is leakage at any of the components then the machine will detect this and P1 icon will flash on the Programme indicator. As long as the overflowing continues safety algorithm will be active and try to discharge the water. If overflowing stops and safety is assured, P1 icon will disappear. If P1 does not disappear, there is a permanent fault. In this case the authorised service should be contacted.