Beko DIN16X10 Owners Manual - Page 31

OperatIng the product Adjusting the amount of rinse aid 1. After turning on your machine, press and hold the Time Delay and Start / Pause / Cancel keys respectively. 2. Using the Time Delay key, turn on the 6 LED. 3. You can use the function keys to adjust the rinse aid level. If the 1st programme indicator is on, no rinse aid will be dispensed If the 2nd programme indicator is on, 1 dose of rinse aid will be dispensed. If the 3rd programme indicator is on, 2 doses of rinse aid will be dispensed. If the 4th programme indicator is on, 3 doses of rinse aid will be dispensed. If the 1st, 2nd, 3rd and 4th programme indicators are on, 4 doses of rinse aid will be dispensed. 4. Press the On/Off key to exit the settings menu. Your setting will be saved automatically. End of programme C When the programme you have selected comes to an end, an audible warning signal will warn you to turn off your machine. This audible signal will warn you with certain intervals before it turns off. Start / Pause indicator will go off once the washing programme has ended. 1. Open the door of the machine. 2. Press the On/Off key to switch off your machine. 3. Close the tap. 4. Unplug the machine from the socket. C For energy saving, the machine is automatically switched off following the completion of the programme or when the programme is not started. C Leave your dishes in the machine for about 15 minutes after they are washed in order to have them cooled. Your dishes will dry in a shorter time if you leave the door of your machine ajar during this period. This process will increase the drying effectiveness of your machine. Water Cut-off Warning If mains water is cut off or water inlet tap is turned off, the machine will not take water in and water off indicator will flash. As long as the problem continues, washing programme is paused and the water inlet is checked regularly by the machine; when the water is restored water off indicator will disappear after a while and the washing programme resumes. Overflowing Warning If the machine intakes too much water or there is leakage at any of the components then the machine will detect this and water overflow indicator will flash on the Programme indicator. As long as the overflowing continues safety algorithm will be active and try to discharge the water. If overflowing stops and safety is assured, water overflow indicator will disappear. If the indicator does not disappear, there is a permanent fault. In this case the authorised service should be contacted. Dishwasher / User's Manual 29/43 EN