Beko DVN05Q20 Owners Manual - Page 12
Installation
View all Beko DVN05Q20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4- Installation Read "Safety Instructions" section first! Installation procedures must always be performed by the manufacturer, authorised service agent or a qualified person specified by the importer. To make the product ready for use, make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the authorised service agent. If they are not, call a qualified technician and plumber to have the necessary arrangements carried out. Preparation of the location and electrical, tap water and waste water installations at the place of installation is under customer's responsibility. Installation and electrical connections must be carried out by the authorised service agent. Manufacturer shall not be held responsible for damages arising from processes carried out by unauthorised persons. Prior to installation, check if the product has any defects on it. If the product is damaged, do not have it installed. Damaged products cause risks for your safety. Make sure that the water inlet and discharge hoses are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures. The front of the appliance may not be removed on free-standing or under-thecounter models. The warranty will be void if this is done. When placing the product, pay attention not to damage the floor, walls, piping, etc. Do not hold the product from its door or panel to move it. Appropriate installation location In the area where this product is installed, there must not be a lockable, sliding or hinged door that will restrict full opening of the product's door. Make sure that you select a location that will allow you to load and unload the dishes in a fast and comfortable manner. • Place the product on a solid and flat floor that has sufficient load carrying capacity! The product must be installed on a flat surface in order for the door to be closed properly and securely. • Do not install the product at places where temperature may fall below 0ºC. • Place the product on a hard floor. Do not place it on a long pile rug or similar surfaces. Do not place the product on the power cable. • Make sure that you select a location that will allow you to load and unload the dishes in a fast and comfortable manner. • Install the product at a place close to the tap and the drain hole. Select the installation location by considering that it will not be changed after the connections are made. Connecting water supply We recommend installing a filter at the water inlet in order to prevent the dirt (sand, clay, rust) in the mains or water installation of your home from damaging the machine or the dishes. 12/EN