Beko HCAW64225S User Manual - Page 11
Before, installation
View all Beko HCAW64225S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
M Installation Product must be installed by a qualified person in accordance with the regulations in force. The manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorized persons which may also void the warranty. Preparation of location and electrical and gas installation for the product is under the installer's responsibility. f\ DANGER: • I The product must be installed in accordance with all local gas and/or electrical regulations. • DANGER: • T Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. Before installation The hob is designed for installation into commercially available work tops. A safety distance must be left between the appliance and the kitchen walls and furniture. See figure (values in mm). • It can also be used in a free standing position. Allow a minimum distance of 650 mm above the hob surface. • (*) If a cooker hood is to be installed above the cooker, refer to cooker hood manufacturer' instructions regarding installation height (min 650 mm) • Remove packaging materials and transport locks. • Surfaces, synthetic laminates and adhesives used must be heat resistant (100 °C minimum). • The worktop must be aligned and fixed horizontally. • Cut aperture for the hob in worktop as per installation dimensions. 40Umm min 110 nim min 480-490 60MM min, 50mm MI Minimum height to extractor as recommend in extractor instruction manual Minimum distance between cabinetry must be equal to width of hob Room ventilation All rooms require an openable window, or equivalent, and some rooms will require a permanent vent as well. The air for combustion is taken from the room air and the exhaust gases are emitted directly into the room. Good room ventilation is essential for safe operation of your appliance. If the room where the appliance is installed does not have a door or a window that opens directly to the outer environment, there must definitely be a fixed ventilation opening in the room. The fixed ventilation must be nonadjustable and non-closable. On the doors or windows that open directly to the outer environment, there must be a ventilation opening with the dimensions specified based on the total gas power of the appliance (as shown below). You can find the gas power and ventilation opening match-up in the table below. 11/EN