Beko QHGW6422B User Manual - Page 12

Installation, connection

Page 12 highlights

Room ventilation All rooms require an openable window, or equvalent, and some rooms will require a permanent vent as well. The air for combustion is taken from the room air and the exhaust gases are emitted directly into the room. Good room ventilation is essential for safe operation of your appliance. If there is no window or door available for room ventilation, an extra ventilation must be installed. The appliance may be located in a kitchen, kitchen/diner or a bed-sitting room, but not in a room containing a bath or shower. The appliance must not be installed in a bed-sitting room of less than 20m3. Do not install this appliance in a room below ground level unless it is open to ground level on at least one side. Room size smaller than 5 in' Ventilation o ening min, 100 cm 5 in3 to 10 in3 greater than 10 m3 min. 50 cm` not required In the cellar or basement min. 65 cm2 Installation and connection • Product can only be installed and connected in accordance with the statutory installation rules. Electrical connection Connect the product to a grounded outlet/line protected by a fuse of suitable capacity as stated in the "Technical specifications" table. Have the grounding installation made by a qualified electrician while using the product with or without a transformer. Our company shall not be liable for any damages that will arise due to using the product without a grounding installation in accordance with the local regulations. / DANGER: •Y The product must be connected to the mains supply only by an authorised and qualified person. The product's warranty period starts only after correct installation. Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. DANGER: The power cable must not be clamped, bent or trapped or come into contact with hot parts of the product. A damaged power cable must be replaced by a qualified electrician. Otherwise, there is risk of electric shock, short circuit or fire! • Connection must comply with national regulations, . The mains supply data must correspond to the data specified on the type label of the product. Type label is at the rear housing of the product. . Power cable of your product must comply with the values in "Technical specifications" table. ` DANGER: • Before starting any work on the electrical installation, disconnect the product from the mains supply. There is the risk of electric shock! Power cable plug must be within easy reach after installation (do not route it above the hob). Plug the power cable into the socket. Gas connection ^ DANGER: • Product can be connected to gas supply system only by an authorised and qualified person, Risk of explosion or toxication due to unprofessional repairs! Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. 12/EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Room
ventilation
Al
l
rooms
require
an
openable
window,
or
equvalent,
and
some
rooms
will
require
a
permanent
vent
as
well
.
The
air
for
combustion
is
taken
from
the
room
air
and
the
exhaust
gases
are
emitted
directly
into
the
room.
Good
room
ventilation
is
essential
for
safe
operation
of
your
appl
iance.
If
there
is
no
window
or
door
available
for
room
ventilation,
an
extra
ventilation
must
be
installed.
The
appliance
may
be
located
in
a
kitchen,
kitchen/diner
or
a
bed
-sitting
room,
but
not
in
a
room
containing
a
bath
or
shower.
The
appliance
must
not
be
instal
led
in
a
bed
-sitting
room
of
less
than
20m
3
.
Do
not
install
this
appl
iance
in
a
room
below
ground
level
unless
it
is
open
to
ground
level
on
at
least
one
side.
Room
size
Ventilation
o
ening
smaller
than
5
in'
min,
100
cm
5
in
3
to
10
in
3
min.
50
cm
`
greater
than
10
m
3
not
required
In
the
cellar
or
basement
min.
65
cm
2
Installation
and
connection
Product
can
only
be
instal
led
and
connected
in
accordance
with
the
statutory
instal
lation
rules.
Electrical
connection
Connect
the
product
to
a
grounded
outlet/line
protected
by
a
fuse
of
suitable
capacity
as
stated
in
the
"Technical
specifications"
table.
Have
the
grounding
installation
made
by
a
qualified
electrician
while
using
the
product
with
or
without
a
transformer.
Our
company
shall
not
be
l
iable
for
any
damages
that
will
arise
due
to
using
the
product
without
a
grounding
installation
in
accordance
with
the
local
regulations.
/
DANGER:
Y
The
product
must
be
connected
to
the
mains
supply
only
by
an
authorised
and
qualified
person.
The
product's
warranty
period
starts
only
after
correct
installation.
Manufacturer
shall
not
be
held
responsible
for
damages
arising
from
procedures
carried
out
by
unauthorised
persons.
DANGER:
The
power
cable
must
not
be
clamped,
bent
or
trapped
or
come
into
contact
with
hot
parts
of
the
product.
A
damaged
power
cable
must
be
replaced
by
a
qualified
electrician.
Otherwise,
there
is
risk
of
electric
shock,
short
circuit
or
fire!
.
.
Connection
must
comply
with
national
regulations,
The
mains
supply
data
must
correspond
to
the
data
specified
on
the
type
label
of
the
product.
Type
label
is
at
the
rear
housing
of
the
product.
Power
cable
of
your
product
must
comply
with
the
values
in
"Technical
specifications"
table.
`
DANGER:
electrical
installation,
disconnect
the
product
from
the
mains
supply.
There
is
the
risk
of
electric
shock!
Before
starting
any
work
on
the
Power
cable
plug
must
be
within
easy
reach
after
installation
(do
not
route
it
above
the
hob).
Plug
the
power
cable
into
the
socket.
Gas
connection
^
DANGER:
Product
can
be
connected
to
gas
supply
system
only
by
an
authorised
and
qual
ified
person,
Risk
of
explosion
or
toxication
due
to
unprofessional
repairs!
Manufacturer
shall
not
be
held
responsible
for
damages
arising
from
procedures
carried
out
by
unauthorised
persons.
12/EN