Beko TM1546 User Manual - Page 6

Transportation Instructions, Installation Instructions

Get Beko TM1546 PDF manuals and user guides View all Beko TM1546 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

TRANSPORTATION INSTRUCTIONS 1.The appliance should be transported only in an upright position. The packing as supplied must be intact during transportation. 2.If during the course of transport the appliance has to be transported horizontally, it must only be laid on its left hand side when standing in the front of the appliance. After bringing it to upright position,it must not be operated for at least 12 hours to allow the system to settle. 3.Failure to comply with the above instructions could result in damage to the appliance, for which the manufacturer will not be held liable. 4.The appliance must be protected against rain, moisture and other atmospheric influences. 5. When positioning your appliance take care not to damage your flooring, pipes, wall coverings etc. Do not move the appliance by pulling by the door or handle. 6. Empty any water in the drain tray before moving. See section „Defrosting" and „Care & cleaning" for further information. 7. Make sure that the defrost water pipe at the back of the product is fixed to the plastic evaporating pan on the top of the compressor, to avoid defrost water spillage on the floor. Important! • Care must be taken while cleaning/carrying the appliance not to touch the bottom of the condenser metal wires at the back of the appliance, as this could cause injury to fingers and hands. • Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance. • Make sure that the mains cable is not caught under the appliance during and after moving, as this could damage the cable. • Do not allow children to play with the appliance or tamper with the controls. BEKO plc declines to accept any liability should the instructions not be followed. INSTALLATION INSTRUCTIONS 1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres. 2. Do not put your fridge freezer in a cold room where the temperature is likely to go below +5 degrees C (41 degrees F) during night time and/or especially in winter. This fridge freezer has been designed to operate in ambient temperatures between +10 and +38 degrees C (50 and 100 degrees F) Therefore if the appliance is installed in an unheated/cold room (eg: conservatory/annex/ shed/garage etc) then the appliance will not operate causing the freezer compartment to run warmer and as a result the storage time of frozen food may be reduced. 3. Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to work harder. If installed next to a source of heat or freezer, maintain the following minimum side clearances: From Cookers From Radiators From Refrigerators or Larder Fridge 2" (50 mm) 12" (300 mm) 1" (25 mm) 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
TRANSPORTATION INSTRUCTIONS
1.The appliance should be transported only in an upright position. The packing as
supplied must be intact during transportation.
2.
If during the course of transport the appliance has to be transported horizontally, it must only
be laid on its left hand side when standing in the front of the appliance. After bringing it to
upright position,it must not be operated for at least 12 hours to allow the system to settle.
3.Failure to comply with the above instructions could result in damage to the
appliance, for which the manufacturer will not be held liable.
4.The appliance must be protected against rain, moisture and other atmospheric
influences.
5. When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the door or handle.
6. Empty any water in the drain tray before moving
. See section „Defrosting” and „Care
& cleaning” for further information.
7. Make sure that the defrost water pipe at the back of the product is fixed to the
plastic evaporating pan on the top of the compressor, to avoid defrost water spillage
on the floor.
Important!
•
Care must be taken while cleaning/carrying the appliance not to touch the bottom of
the condenser metal wires at the back of the appliance, as this could cause injury to
fingers and hands.
•
Do not attempt to sit or stand on top of your appliance as it is not designed for such
use. You could injure yourself or damage the appliance.
•
Make sure that the mains cable is not caught under the appliance during and after
moving, as this could damage the cable.
• Do not allow children to play with t
he appliance or tamper with the controls.
BEKO plc declines to accept any liability should the instructions not be followed.
INSTALLATION INSTRUCTIONS
1.
The space in the room where the appliance is installed must not be smaller than 10
cubic metres.
2.
Do not put your fridge freezer in a cold room where the temperature is likely to go
below +5 degrees C (41 degrees F) during night time and/or especially in winter.
This fridge freezer has been designed to operate in ambient temperatures between
+10 and +38 degrees C (50 and 100 degrees F) Therefore if the appliance is
installed in an unheated/cold room (eg: conservatory/annex/
shed/garage etc) then the appliance will not operate causing the freezer
compartment to run warmer and as a result the storage time of frozen food may be
reduced.
3.
Do not place the appliance near cookers, radiators or in direct sunlight as this
will cause your appliance to work harder. If installed next to a source of heat or
freezer, maintain the following minimum side clearances:
From Cookers
2" (50 mm)
From Radiators
12" (300 mm)
From Refrigerators or Larder Fridge
1" (25 mm)
4