Beko WIR86540F1 Owners Manual - Page 16

Adjusting the feet with water level • You must remove the Detergent Drawer to set the Water Level. • For the system to operate properly, the bubble inside the Water Level must be in the middle. • If the bubble inside the Water Level is on the left, the pre-set right foot of the Washing Machine must be adjusted. • If the bubble inside the Water Level is on the right, the pre-set left foot of the Washing Machine must be adjusted. • If the bubble inside the Water Level is at the back, the pre-set front feet of the Washing Machine must be turned to the left (clockwise). • If the bubble inside the Water Level is at the front, the pre-set front feet of the Washing Machine must be turned to the right (anti-clockwise). 4.4.7 Electrical connection Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not be liable for any damages that will arise when the product is used without grounding in accordance with the local regulations. • Connection must comply with national regulations. • The wiring for the electrical outlet circuit must be sufficient to meet the appliance requirements. Use of a Groud Fault Circuit Interrupter (GFCI) is recommended. • Power cable plug must be within easy reach after installation. • If the current value of the fuse or breaker in the house is less than 13 Amps, have a qualified electrician install a 13 Amp fuse. • The voltage specified in the "Technical specifications" section must be equal to your mains voltage. • Do not make connections via extension cables or multi-plugs. B WARNING: Damaged power cables must be replaced by the Authorised Service Agents. 16 / EN Washing Machine / User's Manual