Beko WMB61222 User Manual - Page 11

Installation 3. Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P) Blue hose (right) (max. 25 ºC) is for cold water inlet. C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future. Never move the product without the transportation safety bolts properly fixed in place! 3.4 Connecting water supply C A The water supply pressure required to run the product is between 1 to 10 bars (0.1 - 1 MPa). It is necessary to have 10 - 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure reducing valve if water pressure is higher. If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must install the supplied stopper to the hot water valve before operating the product. (Applies for the products supplied with a blind stopper group.) WARNING: Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will get damaged or the product will switch to protection mode and will not operate. WARNING: Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry. 1. Connect the special hoses supplied with the product to the water inlets on the product. A WARNING: Ensure that the cold and hot water connections are made correctly when installing the product. Otherwise, your laundry will come out hot at the end of the washing process and wear out. 2. Tighten all hose nuts by hand. Never use a tool when tightening the nuts. 3. Open the taps completely after making the hose connection to check for water leaks at the connection points. If any leaks occur, turn off the tap and remove the nut. Retighten the nut carefully after checking the seal. To prevent water leakages and damages caused by them, keep the taps closed when the machine is not in use. Washing Machine / User's Manual 11 / EN