Beko WY104764M User Manual - Page 55

Problem Cause Solution Loading door cannot Loading door lock is activated • Drain the water by running the Pump or be opened. because of the water level in Spin programme. the product. Product is heating up the water or it is at the spinning cycle. • Wait until the programme completes. Loading door lock is engaged. Loading door lock will be deactivated a couple of minutes after the programme comes to an end. • Wait for a couple of minutes for deactivation of the loading door lock. Washing takes Water pressure is low. longer time than specified in the user manual.(*) • Product waits until taking in adequate amount of water to prevent poor washing quality due to the decreased amount of water. Therefore, the washing time extends. Voltage is low. • Washing time is prolonged to avoid poor washing results when the supply voltage is low. Input temperature of water is low. • Required time to heat up the water extends in cold seasons. Also, washing time can be lengthened to avoid poor washing results. Number of rinses and/or amount of rinse water have increased. • Product increases the amount of rinse water when good rinsing is needed and adds an extra rinsing step if necessary. Excessive foam has occurred and automatic foam absorption system has been activated due to too much detergent usage. • Use recommended amount of detergent. Programme Timer may stop during water time does not intake. countdown. (On models with display) (*) • Timer indicator will not countdown until the product takes in adequate amount of water. The product will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer indicator will resume countdown after this. Timer may stop during heating • Timer indicator will not countdown step. until the product reaches the selected temperature. Timer may stop during spinning step. • Automatic unbalanced load detection system is activated due to the unbalanced distribution of the laundry in the product. Programme time does not countdown. (*) There is unbalanced load in the • Automatic unbalanced load detection product. system is activated due to the unbalanced distribution of the laundry in the product. Washing Machine / User's Manual EN / 55