Belkin F1DA104Q User Manual - Page 17

INSTALLATION Example of Daisy-Chain Configuration: cable 1 Slave Input VGA Master Input /Slave Output VGA08 USB08 VGA07 06 VGA06 USB 06 VGA05 VGA04 USB 04 VGA03 08 USB 07 07 06 USB 05 05 04 USB 03 03 Master unit (BANK 00) VGA 02 USB02 VGA01 02 USB 01 01 cable 2 Slave Input VGA Master Input /Slave Output VGA08 USB08 VGA07 06 VGA06 USB 06 VGA05 VGA04 USB 04 VGA03 08 USB 07 07 06 USB 05 05 04 USB 03 03 Slave unit (BANK 01) VGA 02 USB02 VGA01 02 USB 01 01 cable 3 Slave Input VGA Master Input /Slave Output VGA08 USB08 VGA07 06 VGA06 USB 06 VGA05 VGA04 USB 04 VGA03 08 USB 07 07 06 USB 05 05 04 USB 03 03 Slave unit (BANK 02) VGA 02 USB02 VGA01 02 USB 01 01 Slave Input VGA Master Input /Slave Output VGA08 USB08 VGA07 06 VGA06 USB 06 VGA05 VGA04 USB 04 VGA03 VGA 02 USB02 VGA01 08 USB 07 07 06 USB 05 05 04 USB 03 03 Slave unit (BANK 03) 02 USB 01 01 Connecting the Computers: 9. Connect all computers to the Master and Slave switches. Refer to "Single PRO2 Installation" on page 10 for instruction on how to connect the Console and the computers to the PRO2. 10. Connect the power supply to the Master switch. Power up the Master switch. You should see the Master switch light up and display the digits "00", indicating its BANK address. 11. Power up the Slave switches sequentially, beginning with Bank 01, by connecting each unit's power supply. Each switch should display its corresponding BANK address number as it is powered up. Note: If the PRO2s do not enumerate correctly, reset the Master switch (BANK 00) by simultaneously pressing the "BANK +" and "BANK -" buttons. You can also reset the Master switch to detect newly added Slave switches. If the switches still do not enumerate correctly, check that all switches have the correct BANK address assigned to them and that all daisy-chain cables are connected properly. 12. Verify that the Master unit has detected all Slave switches by scrolling through the BANKS using the BANK up and BANK down buttons. If all Slave switches are detected properly, the LED display on the Master switch will register and display the attached Slave switch's BANK address. 15