Belkin F6C800-UNV User Manual - Page 3

Contact Us - problem

Page 3 highlights

CONTACT US Belkin Components, Ltd 501 West Walnut St. Compton, CA • 90220-5221 USA Tel: 310.898.1100 Fax: 310.898.1111 Belkin Components B.V. Starparc Building Boeing Avenue 333 1119 PH Schiphol-Rijk The Netherlands Tel: +31 (0) 20 654 73 00 Fax: +31 (0) 20 654 73 49 Belkin Components, Ltd Unit 13 • Gatelodge Close • Round Spinney Northampton, NN3 8RX UK Tel: +44 (0) 1604678300 • Fax: +44 (0) 1604678330 Belkin Australia Ltd 7 Bowen Cresent West Gosford, NSW 2250 Tel: +61 (02) 4325 4666 Fax: +61 (02) 4325 4277 Please visit www.Belkin.com for battery replacement information. PROBLEM UPS not on, LED not lit UPS always on battery mode Back up time too short TROUBLE SHOOTING POSSIBLE CAUSE SOLUTION On/ Off /Te st but ton not Press the On/Off /Test pushed or pushed less button for more than 3 than 3 second seconds Battery voltage is too low Recharge the UPS at least four hours UPS fault Con tact service per sonne l Power cord loose Re-plug the power cord AC breaker is burned out Replace or reset the or tripped breaker Ac utility voltage is too high or too low, or black Normal condition out Battery not fully charged Recharge the UPS at least four hours UPS is overload Remove some unnecessary loads Charger fault or other Rep lace bat tery. reason Con tact belkin.com The UPS continuous Overload ly beeps Red LED lit Battery failure Rem ove t he non-critical loa ds Rep lace batte ry. Con tact belkin.com

  • 1
  • 2
  • 3

CONTACT US
Belkin Components, Ltd
501 West Walnut St.
Compton, CA • 90220-5221
USA
Tel: 310.898.1100
Fax: 310.898.1111
Belkin Components, Ltd
Unit 13 • Gatelodge Close •
Round Spinney
Northampton, NN3 8RX UK
Tel: +44 (0) 1604678300 • Fax:
+44 (0) 1604678330
Belkin Components B.V.
Starparc Building
Boeing Avenue 333
1119 PH Schiphol-Rijk
The Netherlands
Tel: +31 (0) 20 654 73 00
Fax: +31 (0) 20 654 73 49
Belkin Australia Ltd
7 Bowen Cresent
West Gosford, NSW 2250
Tel: +61 (02) 4325 4666
Fax: +61 (02) 4325 4277
Please visit www.Belkin.com for battery replacement information.
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
On/
Off /Te st but ton not
pushed or pushed less
than 3 second
Press the On/Off /Test
button for more than 3
seconds
Battery voltage is too low
Recharge the UPS at
least four hours
UPS not on,
LED not lit
UPS fault
Con tact service
per sonne l
Power cord loose
Re-plug the power
cord
AC breaker is burned out
or tripped
Replace or reset the
breaker
UPS always
on battery
mode
Ac utility voltage is too
high or too low, or black
out
Normal condition
Battery not fully charged
Recharge the UPS at
least four hours
UPS is overload
Remove some un-
necessary loads
Back up
time too
short
Charger fault or other
reason
Rep lace bat tery.
Con tact belkin.com
The UPS
continuous
ly beeps
Overload
Rem ove t he non-critical
loa ds
Red LED lit
Battery failure
Rep lace batte ry.
Con tact belkin.com