BenQ PB6110 User Manual - Page 15

Remote Control Effective Range, Installing or Replacing the Battery, Introduction, Preset

Get BenQ PB6110 - SVGA DLP Projector PDF manuals and user guides
UPC - 840046007720
View all BenQ PB6110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Preset According to the selected input signal, there are several picture setup options available: Vivid mode, Presentation mode, Gaming mode, Video mode, Cinema mode and Economic mode. Refer to page 26 for more information. Remote Control Effective Range Infra Red (IR) remote control sensors are located on the front and the back of the projector. The remote control must be held at an angle within 30 degrees of the projector's IR remote control sensors to function correctly. The distance between the remote control and the sensors should not exceed 6 meters (19.5 feet). 6m Notes on Remote Control Operation: Make sure that there are no obstacles between the remote control and the IR sensors on the projector that might obstruct the infra-red beam. Installing or Replacing the Battery 1. Pull out the battery holder. 2. Insert the new battery in the holder. 3. Push the holder into the remote control. Avoid excessive heat and humidity. There may be danger of an explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of the used battery according to the manufacturer's instructions. Introduction 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Introduction
11
Remote Control Effective Range
Infra Red (IR) remote control sensors are located on the front and the back of the projector.
The remote control must be held at an angle within 30 degrees of the projector’s IR remote
control sensors to function correctly. The distance between the remote control and the sen-
sors should not exceed 6 meters (19.5 feet).
Notes on Remote Control Operation:
Make sure that there are no obstacles between the remote control and the IR sensors on the
projector that might obstruct the infra-red beam.
Installing or Replacing the Battery
1.
Pull out the battery holder.
2.
Insert the new battery in the
holder.
3.
Push the holder into the
remote control.
Avoid excessive heat and humidity.
There may be danger of an explo-
sion if the battery is incorrectly
replaced. Replace only with the
same or equivalent type recom-
mended by the manufacturer. Dis-
pose of the used battery according
to the manufacturer’s instructions.
Preset
According to the selected input signal, there are several picture
setup options available: Vivid mode, Presentation mode, Gaming
mode, Video mode, Cinema mode and Economic mode. Refer to
page
26
for more information.
6m