BenQ RM8601K Installation Handbook - Page 65
Picture/video, Picture, Noise Reduction
View all BenQ RM8601K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Picture/video No picture is displayed. Possible causes Possible solutions The power cord is not connected. Re-connect the power cord. The main power switch on the back of the displayed is not Make sure the power switch is switched on. switched on. The selected input is not Depending on the selected input, connect the display with connected. the input source using the appropriate cable(s). The display is in Standby mode when the input source is D-Sub (VGA). Check the cable connection. See the user manual for details. Press any of the control panel (keypad) buttons and check if the OSD menu could be displayed. If yes, the problem lies Incorrect cable connection. somewhere else. Try with another display resolution or another graphic card (GPU). Restore the display to the default factory settings. The main board could be Contact the BenQ authorized service partner for damaged. replacement. Screen interference is observed or noise is heard. Possible causes Possible solutions This could be caused by other appliances, traffic, or fluorescent lights in the surroundings. Poor quality cable is used for signal input. • Go to Picture > Noise Reduction. • Move the display to another location to see if the interference is reduced. Try with another video cable. The image has a faulty coloration. Possible causes Possible solutions The video cable is not connected Make sure the video cable is connected firmly to the properly. display. Troubleshooting 65