Beretta DT10 Trident Trap Bottom Single Beretta Over & Under User Manual - Page 21
Recoil Pad
View all Beretta DT10 Trident Trap Bottom Single manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
REPLACEMENT OF THE GEL•TEK RECOIL PAD Some Beretta over and unders come standard with a Gel•Tek recoil pad that can be replaced with other Beretta recoil pads of different thickness and material (optional). By assembling recoil pads of different thickness it is possible to modify the length of pull. WARNING: Check the firearm is unloaded. NOTICE: This operation must be carried out by a competent gunsmith. REPLACING THE GEL•TEK PAD WITH A CONVENTIONAL RECOIL PAD ● With a flathead screwdriver (approx. 4 mm/0.2 in.), pull out retaining clasp of the Gel•Tek recoil pad. (Fig. 41) ● Remove the Gel•Tek recoil pad. ● Unscrew and remove the retaining screws and their bushings from the buttstock, using a Phillips-head screwdriver. ● Pressing the conventional recoil pad firmly against the buttstock, insert the screws through the recoil pad and into the buttstock's pre-drilled holes and tighten them with a Phillips-head screwdriver. It is advisable to oil the screwdriver head in order to facilitate its entry into the rubber material of the pad. ● Tighten the screws. REPLACING A CONVENTIONAL RECOIL PAD WITH A GEL•TEK PAD ● Unscrew and remove the retaining screws with a Phillips-head screwdriver and detach the recoil pad from the buttstock. It is advisable to oil the screwdriver head in order to facilitate its entry into the rubber material of the pad. ● With a flathead screwdriver (approx. 4 mm/0.2 in.), pull out retaining clasp of the Gel•Tek recoil pad. (Fig. 42) ● Insert bushings in their lodgings in the stock insert and securely tighten all screws using a properly sized Phillips-head screwdriver. (Fig. 43) ● Place the pad on the stock, and make sure that all bushings are placed in the proper holes. ● While securely pushing the pad against the stock, push retaining clasp back, until it disappears in the pad assembly. Be sure that the pad fits flush to the stock without movement. (Fig. 44) 49