Biostar 945GC-M7TE Bios Setup - Page 21
Parallel Port Mode, ECP Mode Use DMA, PWRON After PWR-Fail
View all Biostar 945GC-M7TE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
945GC-M7 TE Parallel Port Mode The default value is SPP. The Choices: SPP (default) Using Parallel port as Standard Printer Port. EPP Using Parallel Port as Enhanced Parallel Port. ECP Using Parallel port as Extended Capabilities Port. ECP +EPP Using Parallel port as ECP & EPP mode. ECP Mode Use DMA Select a DMA Channel for the port. The Choices: 3 (default), 1. PWRON After PWR-Fail This setting specifies whether your system will reboot after a power fail or interrupts occurs. Off Leaves the computer in the power off state. On Reboots the computer. Former-Sts Restores the system to the status before power failure or interrupt occurs. The Choices: Off (default), On, Former-Sts. 20
945GC-M7 TE
20
Parallel Port Mode
The default value is SPP.
The Choices:
SPP
(default)
Using Parallel port as Standard Printer Port.
EPP
Using Parallel Port as Enhanced Parallel Port.
ECP
Using Parallel port as Extended Capabilities Port.
ECP+EPP
Using Parallel port as ECP & EPP mode.
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices:
3
(default), 1.
PWRON After PWR-Fail
This setting specifies whether your system will reboot after a power
fail or interrupts occurs.
Off
Leaves the computer in the power off state.
On
Reboots the computer.
Former-Sts
Restores the system to the status before power failure or
interrupt occurs.
The Choices: Off
(default), On, Former-Sts.